GE / General Electric Range Surface Element Infinite Switch Control, 2000W WG02F00761, Replaces WB24T10026, 164D1816P011

Genuine OEM GE infinite surface-element switch for an 8-inch element. Controls a large surface element rated at approximately 2,040 watts; specification listed as 7.5–9.3 amps at 240 volts. Also described as a burner-control or infinite switch.

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• The controlled surface element does not turn on.
• The element heats only at full power or on one setting.
• The element stays on or does not respond correctly to the control knob.
• The element cycles erratically or heats intermittently.

Check Before Replacing

• Confirm the issue is limited to the surface element controlled by this switch and that the range has power.
• With the range disconnected from electrical power, inspect the switch terminals and connected wiring for loose, overheated, or visibly damaged connections.
• Compare the affected element’s behavior with another surface element of the same type, while avoiding contact with hot surfaces.
• If qualified to perform electrical testing, follow the appliance service documentation to test the switch for appropriate continuity at the relevant control positions; do not test energized terminals unless using procedures and equipment intended for that purpose.

Pro Tip

Part Details

Key Features

• Genuine OEM GE / General Electric range surface-element infinite switch.
• For an 8-inch large surface element.
• Controls an element rated at approximately 2,040 watts.
• Electrical specification listed as approximately 7.5–9.3 amps at 240 volts.
• Also identified as a burner-control switch or infinite switch.

Installation Notes

• Disconnect electrical power to the range at the circuit breaker or other appropriate disconnect before servicing.
• Verify the replacement is intended for the exact appliance model and the same large-element switch position.
• Photograph or label wire locations before removing the original switch, and transfer connections only according to the appliance’s service documentation.
• Inspect terminals and wiring for heat damage before installation; damaged wiring or connectors may require separate repair.
• After installation, restore power and verify that the controlled element responds correctly through its normal control range while keeping hands and tools away from energized or hot components.

Verified Compatible Models

JB905BH1BB, JB905BH2BB, JB905BH3BB, JB905BH4BB, JB905KH1CC, JB905KH2CC, JB905KH3CC, JB905KH4CC, JB905SH1SS, JB905SH2SS, JB905SH3SS, JB905SH4SS, JB905TH1WW, JB905TH2WW, JB905TH3WW, JCSP42DR1BB, JCSP46DR2WW

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.