Range Wiring Fault or Intermittent Electrical Failure? GE Wire Harness WG02F10989 – Fix It Fast
If your GE or Hotpoint range is experiencing intermittent electrical faults, error codes, or component failures traced to a wiring harness, WG02F10989 is the correct OEM replacement. In most GE-built ranges, secondary wire harnesses route low-voltage signals and power between sub-assemblies — including burner switches, indicator lights, and auxiliary control circuits. When the harness fails due to heat damage, chafing, or connector corrosion, affected circuits go dead or produce erratic behaviour and fault codes. ⚡ Common failure point in GE and Hotpoint-built ranges. Part WG02F10989 is the genuine OEM replacement that restores full circuit integrity and eliminates wiring-related faults.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ QUALIFIER 1 — Range powers on and main functions are partially operational
- ✔ QUALIFIER 2 — Control board and terminal block test OK with no visible damage
- ✔ QUALIFIER 3 — Household circuit breaker and supply voltage confirmed good
- ✔ ONLY problem is intermittent faults, dead circuits, or error codes linked to a secondary harness
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Intermittent error codes with no other obvious failed component
- One or more burner indicator lights not functioning
- Auxiliary circuits (clock, timer, surface light) dead or erratic
- Visible heat damage, melting, or chafing on existing harness wiring
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this wire harness restores normal operation immediately.
📦 Part Details
- Part Number: WG02F10989
- Type: Range Secondary Wire Harness / Electrical Wiring Assembly
- Replaces: 318083023, PS12584804, AP6333282, WG02F10989VP
- Brands: GE, Hotpoint, GE Profile
While the range is open and the harness is being replaced, inspect all connector terminals for heat discolouration, corrosion, or pushed-back pins. A damaged connector will cause the same fault on a new harness. Replace any suspect connectors or terminal blocks at the same time to avoid a repeat repair.
⚙️ Installation
Skill Level: MODERATE — 30–45 Minutes. Disconnect power before servicing. Pull the range away from the wall and remove the back access panel to reach the harness routing. Photograph all connector positions before disconnecting. Transfer connectors one at a time from the old harness to the new to avoid mis-routing, then restore power and verify all affected circuits before reassembling.
✓ Compatible Models
Confirmed compatible with select GE and Hotpoint freestanding and slide-in electric ranges. Contact us to verify your model number before ordering.
💡 Pro Tip
Before removing a single connector, take multiple photos of the full harness routing from different angles. GE secondary harnesses often have similarly sized connectors that can be swapped by mistake — a mis-routed connector will produce the same fault codes as the original failure and is the most common cause of a "new part didn't fix it" callback.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
