Microwave Shutting Off or Not Heating? Thermostat WG02F11614 – Fix Overheating Trips Fast
If your GE microwave shuts off mid-cycle, trips repeatedly, or stops heating without warning, a failed thermal thermostat is the most common cause. In most GE over-the-range microwaves, this is caused by a failed thermostat that can no longer accurately sense or regulate internal temperature. When it fails, the microwave cuts power prematurely to protect the unit, leaving food uncooked and the appliance unusable until it cools or is reset. ⚡ Common failure point in GE-built over-the-range microwaves. Part WG02F11614 is the genuine OEM replacement that restores accurate thermal cutoff protection and eliminates nuisance shutdowns.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Microwave powers on and the control panel is responsive
- ✔ Door switches and interlock system are confirmed working
- ✔ Magnetron and high-voltage components have been ruled out
- ✔ ONLY problem is the unit shutting off during or shortly after starting a cycle
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Microwave shuts off mid-cycle and won't restart until cooled
- Unit runs for a few seconds then cuts out with no error code
- Microwave trips repeatedly even at low power settings
- No heat output despite the turntable and light functioning normally
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this thermostat restores normal microwave operation immediately.
📦 Part Details
- Part Number: WG02F11614
- Type: Bimetal Thermal Thermostat (40/70°C) — temperature-activated cutoff switch that protects the microwave from overheating
- Replaces: WG02F11614, WB27X11213
- Brands: GE, GE Profile
While the microwave is open, inspect the door interlock switches and the high-voltage capacitor for signs of wear or burn marks — these are the next most common failure points in GE over-the-range units and replacing them at the same time avoids a second disassembly.
⚙️ Installation
Skill Level: MODERATE — 20–40 minutes. Disconnect power and discharge the high-voltage capacitor before servicing — microwave capacitors retain a lethal charge even when unplugged. Remove the outer cabinet to access the thermostat location, disconnect the two wire leads, swap in the new thermostat, reconnect the leads, reassemble the cabinet, and test for normal operation.
✓ Compatible Models
Confirmed compatible with JVM1635SLJC01, JVM3160DF5WW, JVM3160RF1SS, JVM3160RF2SS, JVM3160RF3SS, JVM3160RF4SS, JVM3160RF5SS, PVM1899SJC01, PVM2188SJC01, PVM2188SLJC01, PVM9005SJ3SS plus additional GE and GE Profile models. Contact us to verify your model number before ordering.
💡 Pro Tip
Microwave high-voltage capacitors can hold a charge of 2,000V or more for hours after the unit is unplugged. Before touching any internal components, discharge the capacitor using an insulated screwdriver or a discharge tool across the terminals. Skipping this step is the most common cause of serious injury during microwave repairs.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
