Appliance Not Responding? GE Relay Daughter Board WG02F11864 – Fix Relay Control Failures Fast

When your GE appliance stops responding to commands or cycles erratically, the relay daughter board is the most common culprit. In most GE and Hotpoint appliances, this is caused by a failed relay daughter board. When it fails, the appliance may not start, stop mid-cycle, or fail to respond to control inputs entirely. ⚡ Common failure point in GE-built appliances. Part WG02F11864 is the genuine OEM replacement that restores full relay control and normal appliance operation.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ QUALIFIER 1 — appliance powers on / runs normally in some modes
• ✔ QUALIFIER 2 — other control functions work intermittently or not at all
• ✔ QUALIFIER 3 — power supply to the board confirmed OK
• ✔ ONLY problem is relay response failure or erratic cycling

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Appliance does not start or respond to control inputs
• Unit stops mid-cycle without warning
• Relay clicks but appliance does not engage
• Intermittent operation — works sometimes, fails randomly

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this relay daughter board restores normal operation immediately.

📦 Part Details

• Part Number: WG02F11864
• Type: Relay Daughter Control Board — OEM Electronic Component
• Replaces: WG02F10560, WG02F11864
• Brands: GE, Hotpoint, GE Appliances

⚙️ Installation

Skill Level: MODERATE — 30–45 minutes. Disconnect power before servicing. Disconnect the wiring harness from the old board, unscrew the mounting bracket, swap in the new WG02F11864, reconnect the harness, and restore power to test.

✓ Compatible Models

Confirmed compatible with select GE and Hotpoint appliance models using the WG02F10560 or WG02F11864 board. Contact us to verify your model number before ordering.

💡 Pro Tip