GE Built-In Refrigerator Not Cooling or Compressor Failed? Compressor Kit WG03F00154 – Fix Sealed System Fast

A GE Monogram or built-in column refrigerator that has completely stopped cooling, has a compressor that won’t start, or is short-cycling with no temperature recovery has a failed sealed system — and the compressor kit is the definitive fix. In most GE Monogram ZIS, ZIF, and ZISS series built-in refrigerators, the compressor kit WG03F00154 is the heart of the sealed cooling system — pressurizing refrigerant to drive heat transfer across all cooling zones. When it fails, the refrigerant circuit stops, temperatures rise, and no amount of control board or fan replacement will restore cooling. ⚡ The most common sealed-system failure in GE Monogram built-in column refrigerators. Part WG03F00154 is the genuine OEM compressor kit that restores full sealed-system operation and gets your refrigerator cooling again.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your refrigerator powers on — lights, display, and fans are operational
• ✔ The condenser and evaporator fans are running normally
• ✔ Refrigerant charge has been verified — no leak detected in the sealed system
• ✔ The start relay has been tested and confirmed functional — no rattle when shaken
• ✔ ONLY problem is the compressor not starting, short-cycling, or confirmed mechanically seized

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Refrigerator not cooling at all — most common search: “GE Monogram fridge not cold”
• Compressor clicks on then immediately shuts off — short-cycling every few minutes
• Compressor completely silent — no attempt to start during cooling cycle
• Compressor hot to the touch and tripping thermal overload protector
• Loud clicking, buzzing, or humming from the compressor compartment at startup
• All fans running normally but no cooling — sealed system confirmed not pressurizing

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this compressor kit restores full sealed-system cooling operation.

📦 Part Details

• Part Number: WG03F00154
• Type: Hermetically Sealed Compressor Kit – GE Monogram Built-In Column Refrigerator
• Replaces: OEM direct-fit compressor kit — supersedes 162D2501G187, 200D3993P009, WR01F01523, WR87X10064, WR87X10111, WR87X10121, WR87X10123, WR87X10180, WR90M114 (no modification required)
• Brands: GE, GE Monogram
• Note: Tube kit WG03F03655 must be ordered separately if refrigerant lines require replacement

⚙️ Installation

Skill Level: Advanced — EPA 608 Certification Required. Professional installation strongly recommended. Recover all refrigerant before opening the sealed system — venting refrigerant is illegal under Canadian and US environmental regulations. Replace the filter-drier, braze the new compressor WG03F00154 into the sealed system, evacuate to 500 microns minimum, and recharge with the correct refrigerant type and weight from the unit’s data plate. Leak-test all brazed joints before returning the unit to service. Estimated repair time: 3–5 hours including system testing.

💡 Pro Tip

Model hub pages: ZIC360NXALH, ZIC360NXARH, ZIC360NXCLH, ZICP360NXALH, ZICP360NXARH, ZICS360NXALH, ZICS360NRJRH, ZICS360NXDRH, ZIF360NXALH, ZIF360NXARH, ZIF360NHBLH, ZIFP360NXALH, ZIFP360NXARH, ZIFS360NXALH, ZIFS360NXARH, ZISB420DRB, ZISB420DXA, ZISB480DXD, ZISP420DXASS, ZISP480DXASS, ZISP480DXBSS, ZISS360NXASS, ZISS420DRASS, ZISS420DXASS, ZISS480DRASS, ZISS480DXASS

✓ Model-Specific Repair Pages