GE Washer Leaking from the Door? Door Gasket WG04A04082 – Fix Front-Load Seal Failure Fast

A torn, cracked, or mold-damaged door gasket is the most common cause of water leaking from the front of a GE front-load washer. In GE and Hotpoint front-load washers, the door bellows gasket forms the only watertight seal between the door glass and the wash tub — every drop of water that enters the drum passes within millimetres of this seal on every cycle. When the gasket tears, cracks, or collapses at the folds, water escapes onto the floor during wash and spin, and mold colonizes the damaged rubber within days. ⚡ Common failure point in GE front-load washers — gaskets degrade from heat, detergent buildup, and mechanical stress over time. Part WG04A04082 is the genuine OEM replacement that restores a watertight door seal and eliminates leak and mold issues immediately — direct fit, no modifications required.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and runs through cycles normally
• ✔ Drum, motor, and drain function correctly — only the door seal is affected
• ✔ Water supply and inlet valve confirmed OK
• ✔ ONLY problem is water leaking from the door, torn/cracked gasket, or mold buildup on the door seal

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Water leaking from the front door during wash or spin cycle
• Puddle forming at the base of the washer after each cycle
• Visible tear, crack, or hole in the door bellows rubber
• Black mold or mildew growing on the gasket folds
• Musty or sour odor coming from the washer that won't clear
• Gasket pulling away from the tub or door lip and not seating properly

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing the door gasket restores a watertight seal and eliminates odor immediately.

📦 Part Details

• Part Number: WG04A04082
• Type: Front-Load Washer Door Bellows Gasket — large rubber boot seal between door glass and wash tub
• Replaces: 0020300926E, WH08X28371
• Brands: GE, Hotpoint
• Note: Sold individually. Verify full model number before ordering — gasket dimensions vary by platform.

⚙️ Installation

Skill Level: MODERATE — 45–60 minutes. Disconnect power before servicing. Remove the front panel and door boot clamp rings (inner and outer) to release the old gasket from the tub and door lip. Clean the mounting channel thoroughly before installing the new gasket. Seat the new WG04A04082 into the tub groove first, then work the outer lip over the door frame and reinstall both clamp rings. Verify the gasket seats evenly with no gaps before running a test cycle.

✓ Compatible Models

Confirmed compatible with GFW148SSM1WW plus additional GE and Hotpoint front-load washer models in the GFW148SSM series. Contact us to verify your model number before ordering.

💡 Pro Tip