⚠ This part has been superseded by a newer OEM part number.
WG04A04266 has been replaced by WG04L06597. We recommend ordering the current part for guaranteed fit and full lifespan.
Order WG04L06597 Instead →Dishwasher Door Damaged or Leaking? Outer Door Assembly WG04A04266 – Fix Door Seal Failure Fast
A cracked, warped, or misaligned dishwasher door lets water escape and ruins the seal between cycles. In most GE and Hotpoint dishwashers, this is caused by a failed or damaged outer door assembly. When it fails, the door no longer closes flush, the inner seal loses compression, and water can leak onto your floor during every wash cycle. ⚡ Common failure point in GE-built dishwashers. Part WG04A04266 is the genuine OEM replacement that restores a tight, flush door closure and eliminates leaks caused by door damage or misalignment.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Dishwasher powers on and runs cycles normally
- ✔ Spray arms, pump, and drain function correctly
- ✔ Water supply and inlet valve confirmed OK
- ✔ ONLY problem is a damaged, cracked, warped, or misaligned outer door panel
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Outer door panel is visibly cracked, dented, or warped
- Door does not close flush or latch properly
- Water leaking from the door edge during wash cycles
- Door seal losing compression due to panel misalignment
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this outer door assembly restores a watertight seal and normal door operation immediately.
📦 Part Details
- Part Number: WG04A04266
- Type: Dishwasher Outer Door Assembly — OEM Genuine GE Part
- Superseded By: WG04L06597
- Brands: GE, Hotpoint
While the door is open, inspect the door gasket/seal for cracks or compression loss. If the seal is flattened or torn, replace it at the same time — a new door panel against a worn seal will still leak.
⚙️ Installation
Skill Level: MODERATE — 30–60 minutes. Disconnect power before servicing. Remove the inner door panel screws to separate the door assembly, disconnect any wiring harness connectors attached to the outer panel, swap the new assembly into place, and reassemble in reverse order. A Torx T20 screwdriver is typically required.
✓ Compatible Models
Confirmed compatible with select GE and Hotpoint dishwasher models. Contact us to verify your model number before ordering.
💡 Pro Tip
A damaged outer door often stresses the latch assembly. Before closing up, test the latch mechanism for smooth engagement. If it feels stiff or doesn't click firmly, replace the latch at the same time — it's a 10-minute add-on that prevents a second service call.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
