GE / General Electric Washer electronic control board WG04F04565, Replaces WH12X10538, WH12X10614

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Cycle will not start or advance
• Washer does not fill, drain, agitate, or spin
• Cycles run unusually long or short
• Washer becomes unresponsive or behaves erratically

Check Before Replacing

• Disconnect power before inspecting the control assembly or its wiring.
• Confirm the appliance model and replacement part number match before ordering or installing.
• With power disconnected, inspect accessible control-board connectors and wiring for loose connections, visible damage, corrosion, or heat discoloration.
• Because other components can cause similar symptoms, check the relevant water-supply, drain, door/lid-interlock, and drive-system conditions before attributing the fault to the control board.
• If service information for the specific washer calls for a reset, diagnostic test, or calibration after board replacement, follow that model-specific procedure.

Pro Tip

Part Details

Installation Notes

• Disconnect electrical power before servicing.
• Handle the electronic assembly carefully and avoid unnecessary contact with circuit-board surfaces.
• Access and connector-removal details vary by washer model; use the model-specific service information.
• Reconnect wiring exactly as found and verify all connectors are fully seated before restoring power.
• A reset, diagnostic test, or calibration may be required after installation when specified by the model’s service information.

Verified Compatible Models

GCWN4950D0WS, GCWN4950D1WS, GCWN4950D2WS, GHWN4250D0WW, GHWN4250D1WW, GHWN4250D2WW, GMAN4250F0WS, GMAN4250F1WS, GTAN4250D0WW, GTAN4250D1WW, GTAN4250D2WW, GTAP2250D0WW, GTAP2250D1WW, GTWN4250D0WS, GTWN4250D1WS

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.