WASHER CONTROLS ARE UNRESPONSIVE OR THE WASHER WILL NOT
GE Washer Electronic Control Board / Control Board Assembly WG04F04570, Replaces WH12X10443, Fixes Washer controls are unresponsive or the washer will not start despite confirmed power and intact connections
Genuine GE washer electronic control board assembly used in the controls section of compatible front-load washers. The part is documented as replacing OEM part WH12X10443.
Part WG04F04570Replaces WH12X10443GE
Genuine GE washer electronic control board assembly used in the controls section of compatible front-load washers. The part is documented as replacing OEM part WH12X10443.
Is This the Right Part?
Part NumberWG04F04570
ReplacesWH12X10443
ManufacturerGE
Appliance TypeWasher
Part TypeWasher Electronic Control Board / Control Board Assembly
Common Symptoms
- Control panel does not respond to selections
- Washer will not start or fails to respond to the Start command
- Cycle operation stops or does not complete
- Displayed error codes or abnormal control behavior
- Washer remains stuck in one control state
Check Before Replacing
- Disconnect the washer from electrical power before opening or servicing it.
- Confirm the power cord is firmly connected and the household circuit, fuse, or breaker is functioning.
- With power disconnected, inspect the control-board harnesses and connectors for loose wires, corrosion, damaged terminals, or incomplete insertion.
- Verify that the washer’s door closes and latches correctly before attributing a no-start condition to the control board.
- Use the model-specific service-mode tests or error-code history, when available, to distinguish control symptoms from door-lock, water-supply, drain, sensor, or wiring problems.
Pro Tip
Inspect and reseat the control-board connectors before replacing the board; the model-specific service documentation identifies loose, poorly seated, or corroded connections as possible causes of control-related faults.
Part Details
Part NumberWG04F04570
Part TypeWasher Electronic Control Board / Control Board Assembly
ManufacturerGE
Appliance TypeWasher
Primary FunctionControls washer electronic operation by receiving user selections and communicating with the washer’s main control system.
Cross ReferencesWH12X10443
Key Features
- Genuine GE washer electronic control board assembly
- OEM part number WG04F04570
- Documented replacement for WH12X10443
- Listed in the controls section for compatible GE WCVH4800K-series front-load washers
- Interfaces with the washer control panel and main PCB/control system
Installation Notes
- Disconnect electrical power before servicing.
- Use electrostatic-discharge precautions when handling the electronic control assembly.
- Document connector locations before removal and reconnect each harness to its original location.
- Inspect connectors and wiring during installation; do not install a replacement board with visibly damaged or corroded connections.
- Reinstall all removed panels, grounding components, and protective parts before operating the washer.
- Follow the service procedure for the exact washer model; professional installation is recommended for electronic-control repairs.
✅ Cross Reference Information
WH12X10443
Verified Compatible Models
WCVH4800K0WW, WCVH4800K1WW, WCVH4800K2WW, WCVH4815K0MS
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
- Choosing a selection results in a full page refresh.
