Washer Not Starting, Spinning, or Completing Cycles? Triac Control Board WG04F10980 – Fix Motor Control Failure Fast

If your GE top-load washer won’t start, stops mid-cycle, or the motor runs erratically, the electronic triac control board is the most common root cause. In most GE top-load washers, this is caused by a failed triac control board. When it fails, the board can no longer regulate motor speed or cycle sequencing — the washer may fill with water but refuse to agitate, spin at the wrong speed, or stop completely mid-cycle with no error code. ⚡ Common failure point in GE top-load washers, especially after power surges or repeated overload cycles. Part WG04F10980 is the genuine OEM replacement that restores full motor control and cycle sequencing immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on — lid lock, display, or indicator lights are functional
• ✔ Washer fills with water normally but agitation or spin fails
• ✔ Lid switch and motor have been confirmed functional
• ✔ ONLY problem is motor not running, wrong speed, or cycle not completing

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Washer fills but won’t agitate or spin
• Motor runs at wrong speed — too fast, too slow, or erratic
• Washer stops mid-cycle and won’t restart
• Burning smell from control board area during operation
• Washer starts then immediately stops with no error code
• Spin cycle not engaging despite agitation working

✔ If these symptoms match, the triac control board is the most likely failed component in the system.

✔ In most cases, replacing this control board restores full washer operation immediately.

📦 Part Details

• Part Number: WG04F10980
• Type: Electronic Triac Control Board — regulates motor speed, agitation, and spin cycle sequencing in GE top-load washers
• Replaces: WG04F13001, WH22X38441, WG04F09384, WG04F09688, WG04F10269, WG04F10610, WG04F10671, WH18X24379, WH18X24935, WH18X25896, WG04F12460, WH22X32357, WH22X29556, WH18X28174, WH18X28642, WH18X27754, WH18X26217, WH18X28176, WH18X25395, WH18X26794, WH22X29349, WH18X25298, WH22X28841, WH22X28845, WG04F12669, WG04F12963 — no modification required
• Brands: GE (General Electric)

⚙️ Installation

Skill Level: MODERATE — 30–45 minutes. Disconnect power before servicing. Remove the washer's rear or bottom access panel to locate the control board housing. Photograph all wire harness connections before disconnecting. Unplug each connector from the old board, transfer them to the new WG04F10980 in the same positions, and secure the board in its mounting bracket. Reinstall the panel, restore power, and run a short test cycle to confirm agitation and spin are operating correctly.

✓ Compatible Models

Confirmed compatible with GTW220ACK1WW, GTW330ASK0WW, GTW460ASJ0WW, GTW485ASJ0WW, GTW490ACJ0WW, GTW540ASP0WS, HTW200ASK0WW, HTW240ASK0WS plus 55+ additional GE top-load washer models. Contact us to verify your model number before ordering.

💡 Pro Tip

✓ Model-Specific Repair Pages