Dryer Won't Start or Run? GE Dryer Motor WG04F11703 – Fix Motor Failure Fast

A dryer that won't start, hums but doesn't spin, or stops mid-cycle is almost always a failed drive motor. In most GE dryers, this is caused by a burned-out or seized WG04F11703 dryer motor. When it fails, the drum won't turn, the dryer won't start, or the thermal overload trips repeatedly — leaving clothes wet and the appliance unusable. ⚡ Common failure point in GE-built dryers after 7–12 years of heavy use. Part WG04F11703 is the genuine OEM replacement that restores full drum rotation and normal drying cycles immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Dryer powers on but drum does not spin
• ✔ You hear a hum or buzz when the start button is pressed
• ✔ Drum belt is intact and not broken
• ✔ Door switch and thermal fuse test OK
• ✔ ONLY problem is the motor not running or seizing

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Dryer won't start — no drum movement when start is pressed
• Dryer hums loudly but drum does not turn
• Dryer starts then stops after a few seconds
• Burning smell from motor area during attempted start
• Dryer trips breaker or thermal overload repeatedly
• Drum spins freely by hand but motor won't engage

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this dryer motor restores normal operation immediately.

📦 Part Details

• Part Number: WG04F11703
• Type: Genuine OEM GE Dryer Drive Motor — Item #112 in Diagram
• Replaces: 0184000039 — no modification required
• Brands: GE

⚙️ Installation Notes

Skill Level: MODERATE — 45–75 minutes. Disconnect power before servicing. Remove the dryer front panel and drum to access the motor mounted on the base frame. Disconnect the wiring harness and blower wheel before unbolting the motor. Transfer the blower wheel to the new motor, reinstall in reverse order, and test for proper drum rotation and airflow before reassembling the cabinet. Ensure all wire connectors are fully seated to avoid intermittent faults.

💡 Pro Tip

GFD14JSIN1WW, GFD14JSIN2WW, QFD15ESMN0WW