GE Washer Dispenser Fill Hose WG04F11942 — Fixes Dispenser Leaks / Restores Detergent Water Flow — U.S. Cross-Reference WH01X29652

🇺🇸 Matching U.S. Part Number: WH01X29652

Your GE front-load washer is leaking near the dispenser, detergent is remaining in the drawer after a cycle, or water flow into the dispenser is weak or absent. WG04F11942 is a genuine GE washer dispenser fill hose. The matching U.S. service number is WH01X29652. The hose carries water into the washer’s detergent-dispenser system. A split, loose, or obstructed hose may contribute to water leaking near the dispenser, weak dispenser flow, or detergent remaining in the dispenser after a cycle. ⚡ Common wear point in GE GFW-series front-load washers.

Important: Similar symptoms can also result from a blocked dispenser drawer, loose hose clamp, damaged dispenser housing, inlet-valve problem, restricted nozzle, or insufficient water pressure. Confirm the complete washer model before ordering. Disconnect electrical power, shut off the water supply, and inspect all hose connections and clamps before replacing the part. Check carefully for leaks after service.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and cycles run normally
• ✔ Water supply is connected and inlet valve is functioning
• ✔ Dispenser drawer and housing are intact and unobstructed
• ✔ Hose is visibly split, cracked, loose, or confirmed as the source of the leak

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Water leaking from the dispenser area or around the dispenser drawer
• Detergent or fabric softener remaining in the dispenser after a full cycle
• Weak or absent water flow into the dispenser during the fill phase
• Visible cracking, splitting, or disconnection of the dispenser hose

✔ If these symptoms match and the hose is confirmed as the source, this is the correct replacement part.

✔ May restore proper dispenser water flow when the hose is confirmed defective and related components are functioning correctly.

📦 Part Details

• Canadian Part Number: WG04F11942
• U.S. Regional Equivalent: WH01X29652 (regional service equivalent — not a directional OEM supersession)
• Type: Front-load washer dispenser fill hose — carries water into the detergent-dispenser system
• Brands: GE, Mabe

⚙️ Installation

Skill Level: Easy–Moderate — 20–30 minutes. Disconnect power and shut off the water supply before servicing. Access the dispenser fill hose by removing the dispenser drawer and housing panel. Release the hose clamps, remove the old hose, route the new hose in the same path, secure the clamps, and reassemble. Restore water supply and run a short cycle — inspect all connections carefully for leaks before considering the repair complete.

✓ Compatible Models

Confirmed compatible with GFW510SCN0WW, GFW510SCN1WW, GFW510SCN2WW, GFW510SCN3WW, GFW510SCN4WW, GFW510SCV0WW, GFW550SPN0DG, GFW550SPN1DG, GFW550SSN0WW, GFW550SSN1WW, GFW550SSN2WW, GFW550SSN3WW, GFW650SPN0SN, GFW650SPN1SN, GFW650SSN0WW, GFW650SSN1WW, GFW650SSN2WW, GFW650SSN3WW, GFW650SSN4WW, GFW655SPV0DS, GFW655SSV0WW, GFW850SPN1DG, GFW850SPN1RS, GFW850SPN2RS, GFW850SPN3DG, GFW850SPN3RS, GFW850SPN4RS, GFW850SPN5RS, GFW850SSN3WW, GFW850SSN4WW, GFW850SSN5WW, PFW870SPV0RS, PFW870SSV0WW, PFW950SPT0DS, PFW950SPT1DS, PFW950SPT2DS, PFW950SPT3DS, PFW955SPW0DS, PFW955SPW0GN plus additional GFW550 and GFW650 suffix variants. Contact us to verify your model number before ordering.

💡 Pro Tip

✓ Model-Specific Repair Pages