CYCLE SELECTION WILL NOT SET WITH THE KNOB
GE Washer Knob & Clip Assembly / Washer Control Knob, White WG04L01748, Fixes Cycle selection will not set with the knob
Genuine OEM GE white washer control knob with gray details, supplied as a knob and clip assembly. The knob accepts a D-shaped shaft and mounts to a rotary or starter switch on the washer control panel.
Part WG04L01748GE
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberWG04L01748
ManufacturerGE
Appliance TypeWasher
Part TypeWasher Knob & Clip Assembly / Washer Control Knob, White
✅ Cross Reference Information
Current Part NumberWG04L01748
ReplacesWH01X10313
Common Symptoms
- Control knob is cracked, loose, missing, or will not stay engaged on the shaft.
- Washer setting selection does not respond through this control knob.
- Washer may not start when the affected selector or starter control cannot be operated; other faults can cause the same symptom.
Check Before Replacing
- Disconnect power before inspecting the control-panel knob.
- Check the knob and included clip for cracks, deformation, looseness, or loss of retention on the control shaft.
- Confirm the washer's shaft is D-shaped and that the knob bore can align with it; do not force the knob onto the shaft.
- Verify the appliance model and required control-panel position in its parts documentation before ordering or installing the part.
Pro Tip
Because this is a knob-and-clip assembly, inspect the retaining clip as well as the knob; a sound knob can still fit loosely if the clip is damaged or absent.
Part Details
Part NumberWG04L01748
Part TypeWasher Knob & Clip Assembly / Washer Control Knob, White
ManufacturerGE
Appliance TypeWasher
Primary FunctionProvides the user-operated rotary control interface for selecting or starting washer settings by engaging a D-shaped switch shaft on the control panel.
Installation Notes
- Disconnect electrical power before servicing the control panel.
- Align the knob's D-shaped opening with the matching D-shaped control shaft before seating it.
- Install only on a verified compatible model and matching control-shaft configuration.
- Do not force the knob if it does not align or seat normally; recheck shaft shape, clip condition, and part applicability.
Verified Compatible Models
HTAP1100F0WW, MTAP1100F1WW, MTAP1100F2WW, MTAP1100F0WW
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
