Washer Won't Start or Door Won't Unlock? GE Door Lock Assembly WG04L06679 – Fix Door Lock Error Fast

If your GE front-load washer won't start, displays a door lock error code, or traps clothes inside with the door sealed shut, the door lock assembly is the most likely cause. In most GE GFW-series front-load washers, the door lock interlock is a safety device that must confirm the door is sealed before the cycle can begin — when it fails electrically or mechanically, the washer either refuses to start or locks the door and never releases it. ⚡ Common failure point in GE GFW550, GFW650, and GFW850 front-load washers. Part WG04L06679 is the genuine OEM replacement door lock assembly that restores normal start function and door operation with a direct plug-in fit requiring no modification.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and control panel responds normally
• ✔ Water supply valves are open and inlet hoses are not kinked
• ✔ Door closes fully and latch engages physically
• ✔ ONLY problem is door lock error code, won't start, or door won't release after cycle

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Washer won't start — door lock error code displayed on control panel
• Door locks but cycle never begins — washer sits idle after start button pressed
• Door won't unlock after cycle ends — clothes trapped inside
• Washer stops mid-cycle and door remains locked with no error code
• Intermittent door lock faults — works sometimes, fails randomly
• Visible cracking, melting, or deformation on the latch housing

✔ If these symptoms match, the door lock assembly is the most likely failed component in the system.

✔ In most cases, replacing this door lock assembly restores normal start function and door operation immediately.

📦 Part Details

• Part Number: WG04L06679
• Type: Washer Door Lock / Interlock Assembly — OEM latch with integrated solenoid and wiring harness connector
• Replaces: WH01X29528, 0024000128GE
• Brands: GE, GE Profile

⚙️ Installation

Skill Level: MODERATE — 20–30 minutes. Disconnect power before beginning. Remove the door boot seal retaining ring to access the lock assembly mounted inside the front panel. Disconnect the wiring harness connector, remove the mounting screws, and swap in the new lock. Transfer the harness carefully — do not force or pry the connector. Test door lock operation before reinstalling the front panel.

✓ Compatible Models

Confirmed compatible with GFW550SMN0DG, GFW550SMN0WW, GFW550SMN1WW, GFW550SMN2WW, GFW550SMN3WW, GFW550SSN1WW, GFW650SPN0SN, GFW650SPN1SN, GFW650SPN2SN, GFW650SPN3SN, GFW850SPN0RS, GFW850SPN1RS, GFW850SPN3RS plus additional GE GFW-series front-load washer models. Contact us to verify your model number before ordering.

💡 Pro Tip

✓ Model-Specific Repair Pages