Whirlpool Dishwasher circulation pump and motor assembly W10782773, Fixes Poor cleaning caused by weak or absent wash-water circulation
Genuine Whirlpool circulation pump and motor assembly for dishwashers. The motor and impeller circulate wash water through the spray arms; the assembly includes a small port for the thermistor. Drain pump not included.
Confirm your full appliance model number before ordering.
Is This the Right Part?
✅ Cross Reference Information
Common Symptoms
- Unusual howling or grinding noise during the wash portion of the cycle
- Little or no water movement from the spray arms after the dishwasher fills
- Dishes remain dirty because the circulation pump is not developing adequate spray pressure
- Water leakage from the pump assembly or its seal area
Check Before Replacing
- Confirm that the dishwasher fills with water and drains normally before evaluating the circulation pump.
- After filling, briefly open the door and check for evidence of active water spraying or spray-arm movement; avoid placing hands inside while operating.
- With electrical power disconnected, inspect the accessible pump wiring and connectors for looseness, burn marks, or visible damage.
- With power disconnected, check the sump, filters, spray arms, and pump inlet area for removable debris or obstructions before condemning the pump assembly.
- Distinguish circulation-pump noise during washing from drain-pump operation during draining; the two pumps perform different functions.
Pro Tip
Part Details
Installation Notes
- Disconnect electrical power and shut off the dishwasher water supply before service.
- Remove the lower rack and lower spray-arm assembly as required for access.
- If the dishwasher must be pulled from the cabinet, disconnect the water, drain, and electrical connections carefully and protect the floor from residual water.
- Remove the drain pump, thermistor, wiring harness, and retaining sump tabs or clips as applicable to the installation.
- Seat the replacement assembly by aligning its locating tab or slot, then reinstall the retaining tabs or clips so the assembly is properly seated and sealed.
- Reconnect the circulation-motor harness, thermistor, drain pump, drain hose, and any applicable sensor connections before reassembly; restore water and power and check operation for leaks.
Verified Compatible Models
66514353300, 66514353301, 66515872000, 66515874000, 66515879000, 66515882000, 66515884000, 66515887000, 66515889000, 66515892100, 66515894100, 665110739120, 665110739130, 665110739140, 665110739190
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
