Whirlpool WPW10336133 Dryer Control Board – Dryer Won't Start, Dead Display, or Cycles Fail (NLA – Limited Stock)
⚠️ This part is No Longer Available (NLA) from Whirlpool. We may have limited units remaining on hand — contact us to confirm stock before ordering. Once sold out, this board cannot be restocked from any manufacturer channel. If you need this part, don't wait.
Whirlpool Dryer Dryer Control Board WPW10336133
Is This the Right Part?
Confirm the complete model number before ordering. Similar parts may use different connectors, dimensions, hose positions, electrical ratings, or mounting points.
- Dryer completely dead — no lights, no display, no response to any button
- Dryer won't start even though it has power
- Display blank, flickering, or showing persistent error codes
- Control panel buttons unresponsive or intermittently working
- Dryer starts but stops mid-cycle without completing
- Cycles run but dryer produces no heat
- Timer counts down but drum doesn't turn
- Settings don't save or reset randomly between cycles
- OEM Part Number: WPW10336133
- Part Type: Dryer Control Board (Electronic Control Board / Main PCB / Cycle Control)
- Status: No Longer Available (NLA) — discontinued by Whirlpool, cannot be reordered
- Condition: Genuine OEM — new in manufacturer packaging
- Controls: Cycle selection, temperature regulation, timing logic, safety interlocks
- Platform: Whirlpool dryers
- Common Failure Causes: Power surges, relay fatigue, moisture intrusion, age-related capacitor failure
- Skill Level: Intermediate — comfort with appliance disassembly and harness connectors required
- Always disconnect power (unplug the dryer) before servicing — do not rely on the power switch alone
- Photograph all harness connector positions on the old board before disconnecting anything
- Handle the control board by its edges only — circuit components are static-sensitive
- Transfer connectors one at a time to avoid mis-wiring
- Do not overtighten mounting screws — board standoffs are plastic and will crack
- After installation, restore power and run a full test cycle before closing up the unit
- If error codes persist after install, perform a hard reset: unplug for 60 seconds, then restore power
- NLA note: Confirm stock availability with XPart Supply before ordering — this part cannot be exchanged for a restock if unavailable
A blown thermal fuse is the single most common cause of a completely dead dryer — and it perfectly mimics a failed control board. Before committing to this NLA board (which cannot be returned once installed on most platforms), test the thermal fuse with a multimeter for continuity. It's a $10–15 part and a 20-minute fix. Also check the door switch and start switch for continuity — both can cause a no-start condition that looks identical to a dead board. Rule these out first, then order the board with confidence.
Part Details
Use a qualified technician when diagnosis or installation is outside your experience. Gas parts should be installed by a licensed technician.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
