WASHER DOES NOT PROPERLY ENERGIZE THE WATER INLET VALVE
Whirlpool Washer Valve wire harness W10701401, Fixes Washer does not properly energize the water inlet valve
Genuine Whirlpool OEM valve wire harness for washers.
Part W10701401Whirlpool
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberW10701401
ManufacturerWhirlpool
Appliance TypeWasher
Part TypeValve wire harness
Common Symptoms
- Washer does not fill because the water inlet valve is not receiving electrical connection.
- Intermittent or failed water-inlet operation caused by a damaged or open harness.
Check Before Replacing
- With power disconnected, inspect the harness and connectors for broken wires, loose terminals, corrosion, or visible damage.
- Verify the washer model number against the manufacturer parts diagram before ordering.
- Do not condemn the harness solely from a no-fill symptom; the valve, controls, wiring connections, and water supply can also contribute.
Pro Tip
Match the complete washer model number before installation because this harness is used across multiple brands and model lines.
Part Details
Part NumberW10701401
Part TypeValve wire harness
ManufacturerWhirlpool
Appliance TypeWasher
Primary FunctionConnects the washer’s water inlet valve to the appliance’s electrical circuits.
Installation Notes
- Disconnect electrical power and shut off the water supply before installation.
- Use the appliance’s model-specific service documentation for connector routing and retention.
- Ensure all connectors are fully seated and routed away from moving or sharp components.
Verified Compatible Models
Fitment reminder: Verified compatibility is maintained by the XPart Model Hub Network. Match the complete appliance model number before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
