Fabric Softener or Bleach Not Dispensing? Injector Valve Kit 12001677 – Fix Dispenser Failure Fast

Is your washer's fabric softener or bleach dispenser not releasing additives into the wash cycle? In most Whirlpool, Maytag, and Kenmore top-load washers, this is caused by a failed injector valve kit. When it fails, the dispenser solenoid can't open the valve at the correct cycle point, leaving additives sitting in the cup untouched. ⚡ Common failure point in Whirlpool-built top-load washers with automatic dispenser systems. Part 12001677 is the genuine OEM replacement injector valve kit that restores proper additive dispensing immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your washer powers on and completes wash cycles normally
• ✔ The agitator, pump, and spin functions work correctly
• ✔ Water supply and inlet valves are confirmed OK
• ✔ The dispenser cup is clean and not clogged with residue
• ✔ ONLY problem is fabric softener or bleach not being injected into the wash

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Fabric softener left in dispenser cup after cycle completes
• Bleach not dispensed — clothes come out without bleach treatment
• Additives dispensing at wrong point in cycle (too early or too late)
• Dispenser cup overflowing into drum during fill
• Visible corrosion or cracking on the injector valve body
• Washer completes cycle normally but dispenser never activates

✔ If these symptoms match, the injector valve kit is the most likely failed component in the dispenser system.

✔ In most cases, replacing the 12001677 restores proper additive dispensing immediately.

📦 Part Details

• Part Number: 12001677
• Type: Washer Injector Valve Kit — fabric softener and bleach dispenser solenoid valve assembly
• Replaces: OEM direct-fit injector valve kit — supersedes AP6007491, PS11740603 (no modification required)
• Brands: Whirlpool, Maytag, Kenmore

⚙️ Installation

Skill Level: EASY — 15–20 minutes. Unplug the washer before beginning. The injector valve kit is typically accessed by removing the dispenser assembly from the agitator or top panel depending on model. Disconnect the wiring harness, swap the valve, reconnect, and test with a short cycle. No special tools required.

💡 Pro Tip