Washer Not Filling with Water? Water Inlet Valve W11210463 – Fix No-Fill Fast

If your Whirlpool washer won't fill, fills too slowly, or stops mid-cycle, the water inlet valve is the most common cause. In most Whirlpool top-load washers, the inlet valve controls hot and cold water entry into the drum. When it fails, the washer may fill partially, not at all, or continuously overflow. ⚡ High-failure component in Whirlpool-built top-load platforms. Part W11210463 is the genuine OEM replacement that restores proper water flow and cycle performance immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and agitates normally
• ✔ Drain and spin functions work correctly
• ✔ Home water supply pressure is confirmed OK
• ✔ Lid switch and control board are functioning
• ✔ ONLY problem is no water, slow fill, or incorrect fill level

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Washer not filling with water — most common, what customers search
• Washer fills very slowly or only partially
• No hot water or no cold water entering drum
• Washer overfills and water spills onto floor
• Washer stops mid-cycle during fill phase
• Humming noise from valve area with no water flow

✔ If these symptoms match, the water inlet valve is the most likely failed component in the system.

✔ In most cases, replacing this valve restores normal fill operation immediately.

📦 Part Details

• Part Number: W11210463
• Type: Dual-coil water inlet valve assembly with hot and cold ports
• Replaces: OEM direct-fit valve assembly — supersedes W10701461, W10869803, W10883458, W11038696, W11101906 (no modification required)
• Brands: Whirlpool, Amana, Maytag, Crosley

⚙️ Installation

Skill Level: EASY — 20–30 minutes. Unplug the washer and shut off water supply valves before beginning. Remove the rear access panel, disconnect the wire harness and water lines from the old valve, and reverse the process with the new part. No soldering or special tools required — standard screwdriver and pliers only.

✓ Compatible Models

Confirmed compatible with ITW4971EW1, ITW4871FW3, ITW4671EW1, CAW11544EW2, CAW8350EW2, RTW4516FW2, NTW4665GW0, NTW4655EW1, NTW4605EW1, NTW4516FW4, NTW4516FW3, NTW4516FW2, ATW4516MW0, ATW4516HW0, plus additional Whirlpool-platform models. Contact us to verify your model number before ordering.

💡 Pro Tip

Model repair hubs: ITW4971EW1, ITW4871FW3, ITW4671EW1, CAW11544EW2, CAW8350EW2, RTW4516FW2, NTW4665GW0, NTW4655EW1, NTW4605EW1, NTW4516FW4, NTW4516FW3, NTW4516FW2, ATW4516MW0, ATW4516HW0

✓ Model-Specific Repair Pages