Whirlpool Washer Water Inlet Valve W11614515

Genuine Whirlpool OEM washer water inlet valve that regulates water flow into the washer during filling. The part is documented for Whirlpool and Maytag washers.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your washer powers on and the control board selects cycles normally
• ✔ The drain pump and motor function correctly
• ✔ Household water supply pressure is confirmed adequate (min. 20 PSI)
• ✔ Inlet hoses are not kinked, blocked, or corroded
• ✔ ONLY problem is fill failure, slow fill, overfill, or single-temperature fill

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Washer won't fill with water — cycle starts but tub stays empty
• Washer fills very slowly or takes much longer than normal
• Washer overfills and water spills onto the floor
• Only hot or only cold water enters — not both
• Humming sound during fill phase but no water enters tub
• Water leaking from the inlet valve area at the back of the machine

✔ If these symptoms match, the water inlet valve is the most likely failed component.

✔ In most cases, replacing this valve restores normal fill operation immediately.

✅ Cross Reference Information

Part Details

• Part Number: W11614515
• Part Type: Water Inlet Valve
• Manufacturer: Whirlpool
• Appliance Type: Washer

⚙️ Installation

Skill Level: Easy — 20–30 min. Disconnect power and shut off the water supply before beginning. Access the valve by removing the top panel or rear access panel (model-dependent). Disconnect the inlet hoses, unplug the wire harness connectors, and remove the mounting screws. Install the new valve in reverse order, hand-tighten hose connections only — do not over-torque. Restore water and power, then run a fill cycle and check for leaks before reassembling panels.

💡 Pro Tip

Whirlpool Washer Parts Hub, Maytag Washer Parts Hub

Verified Compatible Models

✓ Model-Specific Repair Pages