Whirlpool Washer Selector Knob - White WP22001663, Replaces 14205107, 22001663, 22003913, 3-8453, 308453, 33002257, Y308453

Genuine Whirlpool selector/control knob, white with black indicator, used to select washer or dryer cycle settings. The knob attaches to the control shaft and is removed by pulling it straight off.

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Cycle setting cannot be selected reliably.
• Control knob turns without engaging the selector shaft.
• Knob is cracked, stripped, loose, or physically damaged.
• Washer or dryer controls appear unresponsive when the knob is turned; other causes are possible.

Check Before Replacing

• Disconnect power before inspecting or removing the knob.
• Visually inspect the knob for cracks, stripped internal gripping surfaces, looseness, or a missing indicator.
• With power disconnected, gently check whether the knob engages the selector shaft rather than spinning freely.
• Confirm that the appliance shaft and replacement knob interface match, including the documented D-shaped shaft design where applicable.
• If the knob engages the shaft normally but the appliance still does not respond, do not assume the knob is the cause; further appliance-level diagnosis may be required.

Pro Tip

Part Details

Key Features

• Genuine Whirlpool OEM selector/control knob.
• White knob with a black indicator arrow.
• Designed for washer, dryer, and some washer/dryer-combo applications.
• Accepts a D-shaped selector-switch shaft on applicable models.
• Approximately 2 inches in diameter according to a technical retailer listing.
• Sold individually.

Installation Notes

• Disconnect appliance power before servicing the control area.
• Remove the existing knob by pulling it straight off the control post; do not twist-force or pry against the control panel.
• Before fitting the replacement, verify that its shaft opening matches the appliance selector post and that the indicator is oriented correctly.
• Press the replacement onto the matching selector post only as far as it seats normally; if it does not fit, stop and recheck the exact model and shaft configuration.
• Restore power and verify selector operation after installation.

Verified Compatible Models

CDE9500AZW, CDE9500W, CDG9500W, CW9500W, SAV505DAWW, SAV5401AWW, SAV5701AWW, SDE505DAYW, SDE505DAZW, SDE5401AYW, SDG405DAWW, SDG505DAXW, SDG5401AWW, SDG5701AWW, SDG5701AXW

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.