WASHER WILL NOT SPIN OR AGITATE BECAUSE THE BELT IS BROKEN, LOOSE, OR SEVERELY WORN
Whirlpool Corporation Washer spin belt / washer drive belt WP27001007, Fixes Washer will not spin or agitate because the belt is broken, loose, or severely worn
Genuine Whirlpool washer spin/drive belt, approximately 30 1/4 inches long and 1/2 inch wide, used to transfer motor power to the washer drive system and spin basket.
Part WP27001007Replaces 27001007, 37820, 40053602, 40053607, 2200062Whirlpool Corporation
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberWP27001007
Replaces27001007, 37820, 40053602, 40053607, 2200062
ManufacturerWhirlpool Corporation
Appliance TypeWasher
Part TypeWasher spin belt / washer drive belt
✅ Cross Reference Information
Current Part NumberWP27001007
Replaces27001007, 37820, 40053602, 40053607, 2200062
Common Symptoms
- Washer does not spin
- Washer does not agitate
- Slow or incomplete spinning, leaving clothes wet
- Burning-rubber odor during operation
- Belt-related squealing, slipping, or unusual noise
- Washer may pump but fail to drive the basket
Check Before Replacing
- Disconnect electrical power before inspection or service.
- Inspect the belt for breakage, fraying, glazing, looseness, separation, or a damaged V-section.
- With power disconnected, check that the belt is seated on the motor and drive pulleys and that it is not visibly slipping off.
- If the belt is damaged, inspect the visible pulleys and surrounding area for obstruction, misalignment, or signs of binding before installing a new belt.
- Do not operate the washer with panels removed or hands near moving components; other faults can produce similar symptoms.
Pro Tip
If the belt is broken or loose, inspect pulley alignment and the drive system for binding or obstruction before installing the replacement; otherwise the new belt may fail prematurely.
Part Details
Part NumberWP27001007
Part TypeWasher spin belt / washer drive belt
ManufacturerWhirlpool Corporation
Appliance TypeWasher
Primary FunctionTransfers motor power to the washer transmission/drive system so the washer can agitate, pump, and spin the basket.
Installation Notes
- Disconnect electrical power before servicing and restore all panels before operation.
- Installation requires access to the washer motor and drive/pump area; the exact access procedure varies by washer model.
- Remove the old belt only after confirming the belt routing and pulley arrangement for the specific washer model.
- Route the replacement belt over the correct pulleys and verify that it is seated properly before reassembly.
- Check pulley alignment and confirm that the belt moves freely without rubbing before operating the washer.
- Verify the appliance model before installation; a belt-related symptom does not by itself prove that the belt is the only failed component.
Verified Compatible Models
ALW110RAW, ALW210RAW, ALW210RMC, ALW210RMW, ALW410DAW, ALW430RAC, ALW430RAW, ALW432RAW, ALW450QAC, ALW450QAW, ALW480DAC, ALW480DAW, ALW540RAC, ALW540RAW, DLW330RAW
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
