Whirlpool Front-Load Washer Detergent Drawer Cracked, Leaking, or Won’t Dispense? Dispenser Drawer WPW10365885 – Fix Dispensing Failures Fast

A cracked, broken, or clogged detergent dispenser drawer is the most common cause of a Whirlpool or Maytag front-load washer that leaks detergent into the drum at the wrong time, leaves detergent residue in the drawer, or fails to dispense fabric softener or bleach correctly. In most Whirlpool, Maytag, and Amana front-load washers, the detergent dispenser drawer is a removable tray that holds and releases detergent, fabric softener, and bleach at the correct points in the wash cycle. When the drawer cracks, warps, or the internal siphon cap breaks, detergent dumps directly into the drum at the start of the cycle instead of being metered out, leaving residue on clothes and in the drawer. ⚡ Common failure point in Whirlpool-built front-load washers after years of detergent and softener buildup. Part WPW10365885 is the genuine OEM replacement that restores correct detergent, softener, and bleach dispensing immediately — directly supersedes W10365885, no modification required.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and wash cycles run normally
• ✔ Dispenser housing (the cavity the drawer slides into) is confirmed intact and not cracked
• ✔ Water inlet to the dispenser is confirmed flowing correctly
• ✔ Detergent and softener being used are the correct type and quantity for HE front-load washers
• ✔ ONLY problem is drawer cracked, broken, leaking, or not dispensing detergent/softener/bleach correctly

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Detergent drawer cracked or broken and leaking onto the floor — most common customer complaint
• Detergent dumps directly into drum at start of cycle instead of being dispensed gradually
• Fabric softener not dispensing — remains in drawer after cycle completes
• Bleach compartment leaking or not dispensing at the correct cycle point
• Detergent residue or buildup accumulating in drawer that won’t clean out
• Drawer won’t slide in or out smoothly due to warping or broken slide tabs

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this dispenser drawer restores correct detergent and softener dispensing immediately.

📦 Part Details

• Part Number: WPW10365885
• Type: Washer detergent dispenser drawer — removable tray with compartments for detergent, fabric softener, and bleach; includes siphon cap for softener metering
• Replaces: OEM direct-fit drawer — supersedes W10365885 (no modification required)
• Brands: Whirlpool, Maytag, Amana, Crosley

⚙️ Installation

Skill Level: EASY — 5 minutes. No tools required and no need to disconnect power for this repair. Pull the old drawer fully out of the dispenser housing by pressing the release tab and lifting. Slide the new WPW10365885 drawer into the housing until it clicks into place. Run a short cycle to confirm detergent and softener dispense correctly before loading laundry. If the drawer doesn’t click firmly into place, check that the housing rails are clean and free of buildup before forcing the drawer in.

💡 Pro Tip

🔗 Model Repair Pages

WFW70HEBW0, WFW80HEBW0, WFW86HEBW0, WFW88HEAW0, WFW90HEFW0, WFW94HEAW0, WFW95HEDW0, WFW85HEFW0, WFW87HEDW0, WFW8640BW0, WFW8740DW0, MHW3000BW0, MHW4200BW0, MHW5500FW0, MHW6000AW0, MHW7000AW0, MHW7100DW0, NFW5700BW0, NFW5800DW0

✓ Model-Specific Repair Pages