CONVECTION FAN DOES NOT RUN
Whirlpool Corporation Range Convection fan motor WPW10389555, Replaces W10389555, Fixes Convection fan does not run
Genuine OEM convection fan motor/convection fan assembly used to circulate hot air through a range oven for even heating.
Part WPW10389555Replaces W10389555Whirlpool Corporation
Genuine OEM convection fan motor/convection fan assembly used to circulate hot air through a range oven for even heating.
Is This the Right Part?
Part NumberWPW10389555
ReplacesW10389555
ManufacturerWhirlpool Corporation
Appliance TypeRange
Part TypeConvection fan motor
✅ Cross Reference Information
Current Part NumberWPW10389555
ReplacesW10389555
Common Symptoms
- Convection fan fails to start or operate.
- Fan runs noisily.
- Uneven baking or roasting when convection mode is used.
- Oven temperature or cooking results are inconsistent during convection cooking.
Check Before Replacing
- With the range unplugged or the circuit breaker off, inspect the convection-fan area for visible obstruction or damage.
- With power disconnected, gently turn the fan blade by hand; unusual resistance or stiffness can indicate a motor or bearing problem, but does not by itself confirm the motor is defective.
- During a convection cycle, observe or listen for fan operation and abnormal noise without touching internal components.
- If electrical testing is performed, follow the appliance’s service documentation and use appropriate electrical-safety procedures; continuity results alone should not be treated as a definitive diagnosis.
Pro Tip
A convection fan that is noisy, stiff to rotate with power disconnected, or fails to start can point toward motor wear, but verify the fan, wiring, controls, and power supply before replacing the motor.
Part Details
Part NumberWPW10389555
Part TypeConvection fan motor
ManufacturerWhirlpool Corporation
Appliance TypeRange
Primary FunctionDrives the oven’s convection fan to circulate heated air through the range oven for more uniform cooking.
Cross ReferencesW10389555
Key Features
- Genuine Whirlpool OEM convection motor/fan assembly.
- Designed for use in select Whirlpool, Maytag, and KitchenAid ranges.
- Replaces Whirlpool part W10389555.
- Provides airflow needed for convection cooking and more even heat distribution.
Installation Notes
- Disconnect electrical power by unplugging the range or switching off the house circuit breaker before installation.
- Wear work gloves when handling the assembly and internal range components.
- Remove the oven racks as needed for access, then disconnect the wire connector before removing the old assembly.
- Install the replacement in the original rear-panel location and reconnect the wiring; use the model-specific service or installation instructions for the exact fastening arrangement.
- Restore power only after the assembly is secured and all connections are complete.
Verified Compatible Models
KERS202BBL0, KERS202BSS0, KERS202BWH0, KGRS202BBL0, KGRS202BSS0, KGRS202BWH0, MER8700DB0, MER8700DB1, MER8700DE0, MER8700DE1, MER8700DH0, MER8700DH1, MER8700DS0, MER8700DS1, MER8700DW0
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
- Choosing a selection results in a full page refresh.
