OEM REPLACEMENT PART
WPW10571738 Dishwasher Adjuster and Wheel Assembly – Genuine OEM
Part# WPW10571738 Replaces W10571738 Fits Whirlpool Fits KitchenAid
Dishwasher Rack Not Sliding? Adjuster and Wheel Assembly WPW10571738 – Fix Broken Rack Wheels Fast
When your dishwasher's upper or lo![]()
wer rack won't slide smoothly, derails, or sits unevenly, a broken adjuster and wheel assembly is the most common cause. In most Whirlpool, KitchenAid, and Maytag dishwashers, this is caused by a cracked or broken rack wheel or adjuster clip. When it fails, the rack tilts, catches on the tub walls, or falls off the track entirely — making loading and unloading difficult and potentially damaging dishes. ⚡ Common failure point in Whirlpool-built dishwashers. Part WPW10571738 is the genuine OEM replacement that restores smooth, level rack operation immediately.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your dishwasher powers on and runs wash cycles normally
- ✔ Water fills and drains correctly
- ✔ The rack track rails inside the tub are intact and undamaged
- ✔ ONLY problem is the rack won't slide smoothly, tilts, or the wheel/adjuster is visibly cracked or broken
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Dishwasher rack won't slide in or out smoothly — catches or drags
- Rack tilts to one side or sits unevenly inside the tub
- Rack derails or falls off the track when pulled out
- Visible cracked, broken, or missing wheel or adjuster clip
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing the adjuster and wheel assembly restores smooth rack operation immediately.
📦 Part Details
-
Part Number: WPW10571738
-
Type: Dishwasher rack adjuster and wheel assembly (mounts to rack side, rides on tub track rails)
-
Replaces: W10571738
-
Brands: Whirlpool, KitchenAid, Maytag, Kenmore
⚠️ Recommended While Repairing:
Rack wheels typically fail in pairs — if one side is broken, inspect the opposite side and all remaining wheels before reassembling. Replacing all worn wheels at the same time prevents a repeat repair within weeks and keeps the rack level for even wash coverage.
⚙️ Installation
Skill Level: Easy — 5–10 minutes. No tools required. Pull the rack out of the dishwasher, locate the broken adjuster/wheel on the rack side rail, squeeze the retaining tabs and pop the old assembly off, then snap the new one into place. Slide the rack back onto the tub rails to confirm smooth operation before running a cycle.
✓ Compatible Models
Confirmed compatible with select Whirlpool, KitchenAid, Maytag, and Kenmore dishwasher models. Contact us to verify your model number before ordering.
💡 Pro Tip
Check the Tub Rails While You're In There:
Before installing the new wheel assembly, run your finger along the plastic tub rail tracks. If they feel rough, cracked, or have raised edges, the rails may be causing premature wheel wear. Smooth any burrs with fine sandpaper or replace the rail caps if damaged — this extends the life of your new wheels significantly.
