Dryer Not Heating? GE Heating Element Assembly WR01F02479 – Fix No-Heat Fast
If your GE or Hotpoint electric dryer runs but produces no heat, a failed heating element assembly is the most common cause. In most GE and Hotpoint electric dryers, this is caused by a failed heating element assembly. When it fails, the drum tumbles normally but clothes come out cold and damp regardless of cycle length or temperature setting. ⚡ Common failure point in GE-built stacked and standalone electric dryers. Part WR01F02479 is the genuine OEM replacement heating element assembly that restores full heating performance and gets your dryer back to normal operation.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Dryer powers on and drum tumbles normally
- ✔ Timer, controls, and door switch function correctly
- ✔ Household 240V circuit breaker and outlet confirmed OK
- ✔ ONLY problem is no heat or insufficient heat during drying cycle
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Dryer runs but produces no heat at all
- Clothes remain damp after a full drying cycle
- Dryer takes multiple cycles to dry a normal load
- Burning smell or circuit breaker tripping during operation
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this heating element assembly restores normal operation immediately.
📦 Part Details
- Part Number: WR01F02479
- Type: Complete Heating Element Assembly — includes housing, nichrome coil, ceramic insulators, high-limit thermal fuse, and operating thermostat
- Replaces: WE11M62, WG01F01543, 189D7110G010, WR01F02479A, WR01F02479B, AP6331670, PS12745416, EAP12745416
- Brands: GE, Hotpoint, MCL
Clean the exhaust vent system thoroughly before installing the new element — blocked vents are the #1 cause of heating element failure. Also test and replace the cycling thermostat if the element failed prematurely. This prevents repeat failures and protects your new part.
⚙️ Installation
Skill Level: ADVANCED — 45–60 minutes. Disconnect power and turn off the 240V circuit breaker before servicing. Access the heating element by removing the dryer back panel or front panel depending on model. Disconnect the wiring harness, remove mounting screws, swap in the new assembly, and reassemble in reverse order. A multimeter is recommended to test the old element and confirm failure before ordering.
✓ Compatible Models
Confirmed compatible with GTUP270EM0WW, GUD27ESMM0WW, GUD27ESSM0WW, GUD37ESMM0DG, MCL1740ESBB0, MCL2040ESBB00, GUAP270EM0WW, GUAN275ED0WW plus additional GE, Hotpoint, and MCL models. Contact us to verify your model number before ordering.
💡 Pro Tip
Use a multimeter set to continuity or resistance. A good heating element reads 8–12 ohms across the terminals. An open (failed) element reads OL or infinite resistance. Confirming failure before ordering saves a return trip and ensures you're replacing the right component.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
