Range Dead or No Power to Controls? GE Wiring Harness WS01F07873 – Fix Electrical Failure Fast
If your GE or Frigidaire range has no power to the control panel, won't turn on, or shows intermittent electrical faults, the main wiring harness is the most common cause. In most GE-built ranges, the main wire harness routes 120V and low-voltage signals between the control board, terminal block, and all major components. When it fails, the range may appear completely dead, lose one or more burners, or throw error codes with no other obvious cause. ⚡ Common failure point in GE and Frigidaire-built ranges. Part WS01F07873 is the genuine OEM replacement that restores full electrical continuity and normal range operation.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ QUALIFIER 1 — Range powers on partially or not at all
- ✔ QUALIFIER 2 — Control board and terminal block test OK
- ✔ QUALIFIER 3 — Household circuit breaker and outlet confirmed good
- ✔ ONLY problem is loss of power or intermittent electrical faults at the harness connector
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Range completely dead — no display, no burners, no response
- Intermittent loss of power to control panel or clock
- One or more burners not receiving power despite good element
- Error codes or fault codes with no other failed component found
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this wiring harness restores normal operation immediately.
📦 Part Details
- Part Number: WS01F07873
- Type: Main Range Wiring Harness / Electrical Wire Assembly
- Replaces: 318083023, PS11770655, AP6278388, WS01F07873VP
- Brands: GE, Frigidaire, Electrolux
While the range is open, inspect the terminal block and control board connectors for heat damage or corrosion — a failing harness often causes arcing at connection points. Replace the terminal block if any burn marks are present to prevent repeat failure.
⚙️ Installation
Skill Level: MODERATE — 30–60 Minutes. Disconnect power before servicing. Pull the range away from the wall, remove the back panel, and photograph all harness routing before disconnecting. Transfer connectors one at a time from old to new harness to avoid mis-routing.
✓ Compatible Models
Confirmed compatible with select GE and Frigidaire freestanding and slide-in electric ranges. Contact us to verify your model number before ordering.
💡 Pro Tip
Before condemning the wiring harness, verify the terminal block where the range cord connects. A loose or arced terminal block can mimic a dead harness and will destroy a new harness if not replaced at the same time. Replacing both together is the safest repair and saves a second service call.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
