Range Not Heating, Showing Error Codes, or Controls Unresponsive? Control Board WS01F09632 – Fix Control Failures Fast

A failed control board assembly is one of the most common causes of a GE Profile range that won't heat, displays persistent error codes, or has completely unresponsive touch controls. In most GE Profile induction and electric ranges, the control assembly manages all cooking functions — burner output, oven temperature, timers, and safety lockouts. When it fails, the range may show F-codes or E-codes, burners or the oven may stop responding entirely, or the display may go blank or behave erratically. ⚡ Common failure point in GE Profile PCHB920-series ranges. Part WS01F09632 is the genuine OEM replacement that restores full control board function and clears fault conditions immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Range has power — display lights up or shows an error code
• ✔ Power supply and breaker confirmed OK — no tripped breaker or wiring fault
• ✔ Temperature sensor tests within spec — not an open or shorted sensor causing the fault
• ✔ ONLY problem is unresponsive controls, persistent error codes, or no heat despite correct settings

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Range displays F-code or E-code error that won't clear
• Touch controls unresponsive or intermittently responsive
• Oven or burners won't heat despite controls appearing to work
• Display blank, flickering, or showing garbled characters

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this control assembly restores full range operation immediately.

📦 Part Details

• Part Number: WS01F09632
• Type: Range Electronic Control Board Assembly
• Replaces: WS01F08992, 295D3464G002
• Brands: GE Profile, GE

⚙️ Installation

Skill Level: MODERATE — 30–45 minutes. Disconnect power at the breaker before servicing. Remove the rear panel or control panel fascia to access the control board mounting. Photograph all wiring harness connections before disconnecting, then transfer each connector to the new board in the same position. Secure the board, reassemble the panel, restore power, and verify all functions — error codes should clear on first power-up.

✓ Compatible Models

Confirmed compatible with PCHB920EM2ES, PCHB920SM2SS, PCHB920YM1FS plus additional GE Profile range models. Contact us to verify your model number before ordering.

💡 Pro Tip