Is This the Part You Need?
If your GE Profile PCGB935 series gas range has gone dark — no display, no heat, no response — the electronic control board is the most common cause. Part WS01F10142 is the current active OEM replacement, superseding the legacy part 295D1508G092. It installs directly with no modifications and restores full oven function including temperature regulation, cook timing, and burner ignition control.
Symptoms This Part Fixes
- Oven completely dead — no display, no response
- Error codes on the control panel (F-codes, E-codes)
- Oven not heating or failing to reach set temperature
- Control panel buttons unresponsive or intermittent
- Oven turns on but shuts off unexpectedly
- Clock or timer not functioning
- Incorrect temperature readings or runaway heat
Part Details
- OEM Part Number: WS01F10142
- Supersedes: 295D1508G092
- Brand: GE (Genuine OEM)
- Appliance Type: Gas Range
- Series: GE Profile PCGB935
- Function: Controls oven temperature, cook timing, burner ignition, and all control panel inputs
- Fit: Direct OEM replacement — no modifications required
- Cross-Reference: WS01F10142 | 295D1508G092
Installation Notes
- Skill Level: Intermediate — comfort with appliance disassembly recommended
- Disconnect power at the breaker before starting — control boards carry live voltage
- The board is located behind the rear control panel; remove all panel screws to access
- Photograph all wire harness connections before disconnecting — label if needed
- Reconnect all harnesses firmly and verify seating before reassembly
- Restore power and test all oven functions before closing the panel
- If error codes persist post-install, perform a hard reset: cut power for 60 seconds, then restore
Compatible Models
💡 Pro Tip — Replace the Igniter While You're In There:
If your range was showing intermittent ignition issues before the board failed, the surface igniter or oven igniter may have contributed to the board overload. Since you're already disassembling the rear panel, it's worth inspecting the igniter resistance (should read 0–1100 ohms). Replacing both in one service call saves a second labour visit and prevents a repeat failure.
If your range was showing intermittent ignition issues before the board failed, the surface igniter or oven igniter may have contributed to the board overload. Since you're already disassembling the rear panel, it's worth inspecting the igniter resistance (should read 0–1100 ohms). Replacing both in one service call saves a second labour visit and prevents a repeat failure.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
- Choosing a selection results in a full page refresh.
