Washer Leaving Detergent Residue? WW01F01653 Recirculation Pump – Fix Wash Performance Fast

If your GE top-load washer is leaving detergent residue on clothes, producing uneven cleaning results, or showing recirculation-related error codes, the recirculation pump assembly is the most likely culprit. In most GE GTW680 and GTW750 series washers, the recirculation pump circulates water from the tub back through the wash basket during the cycle — when it fails, detergent doesn’t distribute evenly and clothes come out soapy or unevenly cleaned. ⚡ Common failure point in GE top-load washers. Part WW01F01653 is the genuine OEM replacement that restores even water and detergent distribution and full wash performance.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and completes cycles normally
• ✔ Washer drains correctly at end of cycle
• ✔ Water supply and inlet valve confirmed OK
• ✔ Agitator or impeller spins normally
• ✔ ONLY problem is detergent residue on clothes, uneven cleaning, or no visible water recirculating through the spray ring

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Detergent residue left on clothes after a full wash cycle — most common complaint
• Uneven cleaning — some items come out dirtier than others
• Washer displays recirculation or flow-related error codes
• Unusual noise or humming from the pump area during the wash cycle
• Water not visibly recirculating through the spray ring or basket
• Clothes smell soapy or feel stiff after washing

✔ If these symptoms match, the recirculation pump is the most likely failed component in the system.

✔ In most cases, replacing the recirculation pump assembly restores normal wash performance immediately.

📦 Part Details

• Part Number: WW01F01653
• Type: OEM recirculation pump assembly for GE top-load washers
• Replaces: OEM direct-fit assembly — supersedes WH23X24175, 290D1226G001 (no modification required)
• Brands: GE

⚙️ Installation

Skill Level: MODERATE — 30–45 minutes. Unplug the washer before beginning any repair. Access the recirculation pump by removing the cabinet side or rear panels depending on your model. Disconnect the hose connections and wire harness from the old pump, seat the new WW01F01653, reconnect all hoses and the harness securely, then reassemble panels and run a test wash cycle to confirm normal recirculation.

💡 Pro Tip

✓ Model Repair Pages

GTW680BSJ0WS, GTW680BSJ1WS, GTW680BSJ2WS, GTW680BSJ3WS, GTW750CPL0DG, GTW750CSL0WS, GTW680BMK0DG, GTW680BMK0WS, GTW680BMM0DG, GTW680BMM0WS, GTW680BMM1DG, GTW680BMM1WS, GTW680BMR0DG, GTW680BMR0WS, LMC74201WDAB00, LMC74201WDAB01, LMH74201WDAB00, LMH74201WDAB01, LMH74201WDAB02, LMH74201WDAB03, LMH74201WDAB04, WMH74201WDAB00, WMH74201WDAB01