GE Washer WW01F020434 Detergent Drawer Genuine OEM
A GE front-load washer that leaves detergent residue in the drawer, fails to dispense fabric softener, or has a cracked or broken dispenser drawer needs a direct OEM replacement — not a workaround. In most GE and Hotpoint front-load washers, the detergent dispenser drawer WW01F020434 houses the detergent, bleach, and fabric softener compartments and routes them into the drum at the correct cycle stage. When the drawer cracks, warps, or the siphon cap fails, detergent bypasses the dispenser and goes directly into the drum at the wrong time, or doesn’t dispense at all. ⚡ One of the most common cosmetic and functional failures on GE front-load washer platforms. Part WW01F020434 is the genuine OEM detergent drawer that restores proper detergent dispensing and eliminates residue buildup.
GE Washer WW01F020434
Is This the Right Part?
Confirm the complete model number before ordering. Similar parts may use different connectors, dimensions, hose positions, electrical ratings, or mounting points.
- ✔ Your washer powers on and runs cycles normally
- ✔ Water fills correctly and the drum spins without issue
- ✔ The dispenser housing (the cavity the drawer slides into) is intact and undamaged
- ✔ The issue is isolated to the drawer itself — cracked, broken tabs, or siphon cap failure
- ✔ ONLY problem is detergent not dispensing, residue left in drawer, or drawer physically damaged
- Detergent left in drawer after cycle — most common search: “GE washer detergent not dispensing”
- Fabric softener not dispensing — remains in compartment after rinse cycle
- Bleach compartment not emptying during wash cycle
- Visible cracks, broken tabs, or warping on the drawer body
- Drawer won’t slide in or out smoothly — catches or sticks in the housing
- Water leaking from the dispenser area during fill cycle
- Part Number: WW01F020434
- Type: Detergent Dispenser Drawer – GE Front-Load Washer
- Replaces: OEM direct-fit drawer assembly (no modification required)
- Brands: GE, Hotpoint
Detergent and fabric softener residue builds up in the dispenser housing cavity over time and will immediately contaminate a new drawer. Before installing WW01F020434, remove the housing insert if equipped, rinse the cavity with warm water, and wipe it dry. This prevents the new drawer from sticking and extends its service life significantly.
Part Details
Use a qualified technician when diagnosis or installation is outside your experience. Gas parts should be installed by a licensed technician.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
