GE Washer Won't Spin or Showing LE Error? Motor Control Board WW01F02067 – Fix Erratic Motor Behavior Fast

When your GE washer won't spin, won't agitate, throws an LE error code, or the motor behaves erratically, the motor control board is the primary suspect. In most GE top-load washers, the motor control (LE) board manages drive motor speed, direction, and torque based on inputs from the main control board and sensors. When it fails, the washer may stop mid-cycle, refuse to spin, display fault codes, or run the motor at incorrect speeds. ⚡ Common failure point in GE-built top-load washers — especially after power surges or water intrusion events. Part WW01F02067 is the genuine OEM replacement that restores full motor control, clears LE fault codes, and returns the washer to normal operation.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and the control panel responds normally
• ✔ Water fills and drains correctly — only spin/agitate is affected
• ✔ LE error code is present, OR motor runs erratically or not at all
• ✔ ONLY problem is motor-related — drum won't move or moves incorrectly

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Washer won't spin or agitate — drum sits still during cycle
• LE error code displayed on control panel
• Motor runs at wrong speed or direction — erratic drum movement
• Washer stops mid-cycle with no error, or resets repeatedly

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this motor control board restores normal operation immediately.

📦 Part Details

• Part Number: WW01F02067
• Type: Motor Control Board (LE Board / Inverter Board / Control PCB)
• Replaces: 233D2319G106
• Brands: GE
• Application: GE Top-Load Washer Drive Motor Control

⚙️ Installation

Skill Level: MODERATE — 30–45 minutes. Disconnect power before servicing. Access the motor control board by removing the washer cabinet or rear panel depending on model. Photograph all wiring connections before disconnecting. Swap the board, reconnect all harnesses in the original configuration, and reassemble. Run a spin cycle to confirm the LE error is cleared and motor operates normally.

✓ Compatible Models

Confirmed compatible with GTW451BMR0WS, GTW490BMR0WS, GTW550BMR0WS plus additional GE top-load washer models. Contact us to verify your model number before ordering.

✓ Model-Specific Repair Pages

💡 Pro Tip