Washer Lid Won't Lock or Cycle Won't Start? WW01L01652 Lid Lock Striker – Fix Lid Lock Failure Fast

If your GE top-load washer won't start, pauses mid-cycle, or displays a lid lock error, the lid lock striker is the most common cause. In most GE and Hotpoint top-load washers, the lid lock striker engages the lid lock switch to signal that the lid is securely closed — when it breaks or cracks, the switch never receives the signal and the washer refuses to run. When it fails, the washer may sit idle at the start of a cycle, stop mid-fill, or throw a lid lock fault code even when the lid appears fully closed. ⚡ One of the most common mechanical failure points on GE GTW and MTW series washers. Part WW01L01652 is the genuine OEM lid lock striker that restores proper lid detection and normal cycle operation immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer has power and controls respond normally
• ✔ Water supply is connected and valves are open
• ✔ Lid closes fully but washer won't start or stops immediately
• ✔ Lid lock switch and wiring harness test OK
• ✔ ONLY problem is lid lock not engaging — striker is cracked, broken, or missing

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Washer won't start — lid lock light flashes or stays off
• Cycle stops immediately after starting — lid lock fault detected
• Lid lock error code displayed on control panel
• Washer pauses mid-fill and won't advance to agitation
• Lid appears closed but washer behaves as if lid is open
• Visible crack, chip, or missing tab on the plastic striker

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing the lid lock striker restores normal cycle operation immediately.

📦 Part Details

• Part Number: WW01L01652
• Type: Washer Lid Lock Striker Assembly — OEM plastic striker tab that engages the lid lock switch
• Replaces: 277B2263G001, 233D2054G002 — no modification required
• Brands: GE, Hotpoint, RCA

⚙️ Installation

Skill Level: Easy — 5–10 minutes. Disconnect power before servicing. The striker is mounted on the underside of the washer lid — remove the single screw or snap-fit clip securing the old striker, align the new WW01L01652 in the same position, and secure it. Close the lid, restore power, and run a test cycle to confirm the lid lock engages and the cycle advances normally.

✓ Compatible Models

Confirmed compatible with GTW220BMK0WW, GTW330BMK1WW, GTW460BMK0WW, GTW485BMM1WS, GTW550BMR0WS, GTW685BMR1WS, MTW200BMK0WW, MTW201BMR0WW plus additional GE and Hotpoint models. Contact us to verify your model number before ordering.

💡 Pro Tip

✓ Model-Specific Repair Pages