GE Washer Outer Tub Kit WW03A00274, Replaces 233D3128G001

Is This the Right Part?

✅ Cross Reference Information

233D3128G001

Common Symptoms

• Water leaking under washer
• Loud grinding or rumbling during spin
• Poor agitation or spin performance
• Off-balance or vibrating loads
• Visible cracks or damage to tub or hub
• Bearing or seal failure

Check Before Replacing

• Confirm the leak originates from the tub or bearing area — not from hose connections, the pump, or the door seal
• Check the inner basket for damage or wobble that may indicate hub or bearing failure
• Inspect the drive components (agitator, wash plate, drive block) for wear before disassembly
• Verify the model number against the confirmed compatible list before ordering — this is a major repair

Pro Tip

Part Details

Installation Notes

• CRITICAL SAFETY WARNING:
• Unplug washer and turn off water supply before repair.
• Unplug washer
• and shut off water.
• Remove top panel and control console
• for tub access.
• Disconnect hoses, wiring, and suspension rods
• from tub assembly.
• Remove agitator or wash plate and inner basket.
• Detach tub mounting hardware
• and lift out old outer tub.
• Clean mounting area and inspect for damage.
• Install new outer tub, subwasher, bearing, and seal
• as per kit instructions.
• Reattach basket, suspension rods, hoses, and wiring.
• Reinstall top panel and control console.
• Restore water and power,
• run a test cycle to check for leaks, smooth spin, and balanced operation.
• Safety Notes:
• Replace agitator or wash plate if worn (not included). Always check for debris in tub and mounting area.

Verified Compatible Models

Fitment reminder: Verified compatibility is maintained by the XPart Model Hub Network. Match the complete appliance model number before ordering.