GE / General Electric Laundry Center Selector Assembly; dryer cycle selector switch assembly WW03F00553

OEM selector assembly used in the dryer section of selected GE laundry centers. The switch selects dryer operating cycles; reported failure symptoms include a selector knob that does not click or fails to change cycles.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Dryer has power and the drum motor runs normally
• ✔ Heating element or gas igniter is confirmed functioning
• ✔ Timer and control board have been ruled out as the failure source
• ✔ Wiring harness to the selector switch is intact with no burnt terminals
• ✔ ONLY problem is the cycle selector knob won't click, runs the wrong cycle, or certain positions don't respond

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Cycle selector knob turns freely with no clicks or detents
• Dryer runs on the same cycle regardless of what position is selected
• Dryer won't start when a specific cycle position is selected
• Switch feels loose, broken, or has no resistance when turned
• Certain cycle positions work but others don't respond
• Dryer starts but immediately stops when a cycle is selected

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this cycle selector switch assembly restores normal cycle selection immediately.

✅ Cross Reference Information

Part Details

• Part Number: WW03F00553
• Part Type: Selector Assembly; dryer cycle selector switch assembly
• Manufacturer: GE / General Electric
• Appliance Type: Laundry Center

⚙️ Installation Notes

Skill Level: BEGINNER–INTERMEDIATE — 20–30 Minutes. Unplug the dryer before beginning any repair. Access the selector switch by removing the control panel — typically secured by screws at the top or rear of the panel. Photograph the wire harness connections before unplugging — terminal positions vary by cycle position. Transfer the knob from the old switch to the new assembly if not included, reconnect all terminals in the correct positions, reassemble the panel, and test each cycle position before closing up.

💡 Pro Tip

GUD27EEMN0WW

Verified Compatible Models

✓ Model-Specific Repair Pages