OVEN DOES NOT IGNITE OR HEAT PROPERLY BECAUSE THE IGNITER IS NOT REACHING SUFFICIENT TEMPERATURE TO OPEN THE SAFETY VALVE
Whirlpool Range Gas oven igniter assembly W10918546, Fixes Oven does not ignite or heat properly because the igniter is not reaching sufficient temperature to open the safety valve
Oven burner igniter for gas ranges. The igniter draws electrical current through the oven safety valve to open the valve and ignite the oven burner.
Part W10918546Replaces 98005652, W10140611, WPW10140611Whirlpool
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberW10918546
Replaces98005652, W10140611, WPW10140611
ManufacturerWhirlpool
Appliance TypeRange
Part TypeGas oven igniter assembly
✅ Cross Reference Information
Current Part NumberW10918546
Replaces98005652, W10140611, WPW10140611
Common Symptoms
- Igniter does not glow during a bake cycle.
- Igniter glows but the burner does not light.
- Igniter glows for more than about 90 seconds without ignition.
- Little or no heat during baking.
- Delayed ignition or a weak orange glow.
- Visible cracking or damage to the igniter ceramic or element.
Check Before Replacing
- With the oven off and cooled, visually inspect the igniter for cracks, damage, or burned wiring.
- During a bake-cycle test, observe whether the igniter glows; do not touch the igniter or burner.
- If the igniter glows for more than approximately 90 seconds without burner ignition, treat the igniter as a possible cause, while recognizing that the gas valve, wiring, or burner may also be involved.
- With electrical power disconnected, verify that the igniter wiring connector is seated and that the harness is not visibly damaged.
- If gas odor is strong or persistent, stop testing, shut off the gas supply if safe to do so, ventilate the area, and seek qualified service.
Pro Tip
A weak igniter can still glow visibly while failing to draw enough current to open the oven safety valve; glow alone does not prove that the igniter is operating correctly.
Part Details
Part NumberW10918546
Part TypeGas oven igniter assembly
ManufacturerWhirlpool
Appliance TypeRange
Primary FunctionThe oven igniter draws current through the oven safety valve, heating until the valve opens and the gas ignites.
Installation Notes
- Disconnect electrical power and shut off the gas supply before servicing the range.
- Allow the oven to cool completely before accessing the igniter.
- Follow the appliance-specific service or installation instructions for access, mounting, and wire connection.
- Handle the ceramic igniter carefully and avoid contact with the heating element.
- After installation, confirm that wiring is routed away from hot burner surfaces and that any disturbed gas connection is checked for leaks before normal operation.
Verified Compatible Models
AGG222VDB1, AGR3311WDQ0, AGR3311WDW1, AGR4230BAW0, AGR4230BAW1, AGR4422VDB0, AGR4433XDB0, AGR4433XDB2, AGR4433XDS1, AGR4433XDW1, AGR5330BAW1, CGRP305TDW0, WFG505M0BS0, WFG505M0BS1, WFG505M0BW0
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
