DISHWASHER WILL NOT START OR TURN ON
Whirlpool Dishwasher Main electronic control board W11305308, Fixes Dishwasher will not start or turn on
Genuine Whirlpool main electronic control board for dishwashers. It manages dishwasher functions including washing, draining, drying, cycle timing, and related operating controls.
Part W11305308Replaces W10918994, W11131683, W11170192, W11227807Whirlpool
Guaranteed to Fit β or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberW11305308
ReplacesW10918994, W11131683, W11170192, W11227807
ManufacturerWhirlpool
Appliance TypeDishwasher
Part TypeMain electronic control board
β Cross Reference Information
Current Part NumberW11305308
ReplacesW10918994, W11131683, W11170192, W11227807
Common Symptoms
- Dishwasher controls may be unresponsive or display flashing lights.
- Cycle may stop before completion or fail to advance normally.
- Dishwasher may not drain, fill, wash, heat, or dry when the board fails to provide the required control signals or power.
- Error codes may appear when control communication or a controlled component is abnormal.
Check Before Replacing
- Confirm the dishwasher has power and that the circuit breaker has not tripped.
- Use the applianceβs model-specific service or diagnostic procedure to check stored codes before replacing the board.
- With power disconnected, inspect the control-board wire harnesses and connectors for loose seating, visible corrosion, heat damage, or broken terminals.
- If qualified to perform electrical testing, verify the model-specific incoming supply voltage at the control board before condemning the board; do not rely on symptoms alone.
- Check related components and wiring because a no-start, drain, heating, or cycle-completion complaint can have causes other than the control board.
Pro Tip
Control boards are frequently misdiagnosed. Verify power, connectors, diagnostic information, and the affected circuit before replacement; a board symptom does not by itself prove board failure.
Part Details
Part NumberW11305308
Part TypeMain electronic control board
ManufacturerWhirlpool
Appliance TypeDishwasher
Primary FunctionMain electronic control board that sequences and coordinates the dishwasherβs wash, drain, heating, drying, and related operating functions.
Installation Notes
- Disconnect electrical power at the circuit breaker or other power source before servicing.
- The documented compatible installation accesses the control board through the dishwasher door by removing the inner-door fasteners.
- Photograph or document connector positions before disconnecting the original board, then reconnect each harness to the corresponding connection.
- Handle the electronic board and connectors carefully; avoid pulling on wires and inspect the replacement for shipping damage before installation.
- Follow the applianceβs model-specific service documentation for any required diagnostic cycle or post-installation checks.
- Do not assume every dishwasher using this part has identical access or fastener details.
Verified Compatible Models
66513355N020, WDT730PAHB0, WDT730PAHV0, WDT730PAHW0, WDT730PAHZ0
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
MonβFri 9β―AMβ5β―PM β’ Sat 9β―AMβ1β―PM
