Whirlpool Washer Water Inlet Valve XP8182862

Whirlpool washer water inlet valve, corresponding to OEM part 8182862 and replaced by WP8182862.

Is This the Right Part?

Common Symptoms

• Slow filling despite adequate water pressure and clean valve screens
• Water leaks at the inlet valve
• No hot or cold water entering the washer
• Overflowing or stopping mid-cycle when the valve malfunctions

Check Before Replacing

• Verify that both household water-supply valves are fully open and water pressure is adequate before replacing the valve.
• Inspect the inlet-hose screens for restriction; the valve should be replaced rather than disassembled or cleaned if the valve itself is defective.
• Check for leaking connections or failure of hot- or cold-water flow into the washer.

Pro Tip

Part Details

Key Features

• Hot-and-cold water inlet valve
• Dual-solenoid valve with thermistor
• Two inlet connections and one outlet connection
• 120 V
• 50 ohm thermistor

Installation Notes

• Disconnect electrical power and turn off the hot and cold water supplies before installation.
• Expect residual water when removing the inlet hoses.
• Reconnect hoses, wiring, and the outlet hose in their original positions, then check for leaks after restoring water and power.

Verified Compatible Models

11045081404, 11045087404, 11045088404, 11045089404, 11045091404, 11045862404, 11045976404, 11047088602, GHW9400SU0, KHWV01RSS0, WFW9300VU02, WFW9300VU03, WFW9300VU04, WFW9400SB00, WFW9400ST00

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.