Menu
GE Fridge Rejecting the Filter or Warning Light Won't Reset? Water Filter XWFE – Fix Filter Recognition Fast
If your GE refrigerator rejects a new water filter, won't reset the "Replace Filter" warning light, or produces water with poor taste or odour, the issue is almost always an incompatible or failed water filter — specifically, installing the older XWF instead of the RFID-equipped XWFE. In most GE French door and side-by-side refrigerators built after 2019, this is caused by using the non-RFID XWF filter in a refrigerator that requires the XWFE — the control board uses an embedded RFID chip to verify and accept the filter. When the wrong filter is installed or the RFID chip fails, the fridge will not seat the filter correctly, the warning light will not clear, and water flow to the dispenser and ice maker may be restricted or cut off entirely. ⚡ The most common filter compatibility issue on post-2019 GE, GE Profile, Café, and Haier refrigerators. Part XWFE is the genuine OEM RFID-equipped replacement that restores full filter recognition, clears the warning light, and delivers NSF-certified clean water immediately.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Refrigerator powers on and cools normally
- ✔ Water supply line to the fridge is connected and valve is open
- ✔ Water inlet valve is not faulty (water reaches the filter housing)
- ✔ ONLY problem is filter rejection, "Replace Filter" light won't reset, reduced water flow, or poor water/ice taste
⚠️ Important: If your refrigerator was manufactured after 2019, it requires the XWFE — not the XWF. The two filters look nearly identical but only the XWFE has the RFID chip required by newer control boards. Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- "Replace Filter" warning light won't reset after installing a new filter
- Refrigerator rejects the filter — won't seat or lock in place
- Reduced or no water flow from the dispenser
- Ice maker producing small, hollow, or cloudy ice cubes
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, installing the correct XWFE filter restores full water flow, clears the warning light, and improves water and ice quality immediately.
📦 Part Details
- Part Number: XWFE
- Type: Refrigerator Water Filter — RFID-equipped, NSF certified, reduces lead, pharmaceuticals, and 50+ impurities
- Replaces: XWF, WR01F04493, WR01F04788
- Brands: GE, GE Profile, Café, Haier
- Replacement Interval: Every 6 months or 300 gallons
⚠️ Replace on Schedule — Don’t Wait for the Warning Light:
The XWFE filter should be replaced every 6 months or 300 gallons regardless of whether the warning light has triggered. An overdue filter reduces flow rate, allows contaminants to pass through, and can cause the ice maker to produce smaller or cloudy cubes. Set a calendar reminder at installation so you never miss a change.
The XWFE filter should be replaced every 6 months or 300 gallons regardless of whether the warning light has triggered. An overdue filter reduces flow rate, allows contaminants to pass through, and can cause the ice maker to produce smaller or cloudy cubes. Set a calendar reminder at installation so you never miss a change.
⚙️ Installation
Skill Level: EASY — 5 minutes. No tools required. No power disconnect needed. Locate the filter housing inside the refrigerator (typically upper right corner of the fridge compartment). Turn the old filter ¼ turn counter-clockwise to remove, insert the new XWFE and turn ¼ turn clockwise to lock. Run 2–3 gallons of water through the dispenser to flush the new filter, then reset the filter indicator light by holding the Reset Filter button for 3 seconds (varies by model).
✓ Compatible Models
Confirmed compatible with CFE26KP2NBS1, CVE28DM5NBS5, GFE26JSMSS, GFE28GYNFS, GNE27JSMSS, GNE29GYNFS, GSE25GGHBB, GSS25GYPFS, PFE28KYNFS, PYE22KYNFS plus 300+ additional GE, GE Profile, Café, and Haier French door and side-by-side refrigerator models. Contact us to verify your model number before ordering.
💡 Pro Tip
Don’t Confuse XWFE with XWF — They Look Identical:
The XWF and XWFE are visually nearly identical — the only external difference is a small RFID chip on the end cap of the XWFE. If your fridge was built after 2019 and you install an XWF, it will not be recognized by the control board and the filter warning will not clear. The XWFE is backward-compatible with older models that accepted the XWF, so when in doubt, the XWFE is always the safer choice.
The XWF and XWFE are visually nearly identical — the only external difference is a small RFID chip on the end cap of the XWFE. If your fridge was built after 2019 and you install an XWF, it will not be recognized by the control board and the filter warning will not clear. The XWFE is backward-compatible with older models that accepted the XWF, so when in doubt, the XWFE is always the safer choice.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
- Choosing a selection results in a full page refresh.
