Midea Dryer Drive Belt 12638200000241 – Fix Drum Not Spinning & No Tumble Fast
Your Midea dryer runs and heats but the drum won’t spin — and a broken or worn drive belt is almost always the cause. In most Midea dryers, the drive belt wraps around the drum, motor pulley, and idler pulley to transfer motor power to the drum. When it breaks or slips off, the motor runs but the drum stays completely still and clothes don’t tumble. ⚡ Most common mechanical failure in Midea-built dryers. Part 12638200000241 is the correct replacement drive belt that restores full drum rotation and normal drying cycles.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your Midea dryer powers on and the motor runs (you can hear it)
- ✔ The dryer heats normally — only the drum is not moving
- ✔ The drum spins freely by hand with no resistance
- ✔ ONLY problem is the drum not rotating during the cycle
Not sure? Send us your model number — we’ll confirm before you order.
🔧 Common Symptoms
- Dryer runs but drum does not spin or tumble
- Motor hums but no drum movement
- Clothes come out wet after a full cycle (drum was stationary)
- Thumping or slapping noise just before drum stopped turning
✔ If these symptoms match, this is the most likely failed component in the drum drive system.
✔ In most cases, replacing the drive belt restores full drum rotation immediately.
📦 Part Details
- Part Number: 12638200000241
- Type: Dryer Drive Belt (Drum Belt)
- Replaces: 12638200000241 — OEM direct replacement
- Brands: Midea
Inspect the idler pulley and drum support wheels while the belt is off. A broken belt often means the idler pulley has seized or the drum wheels are worn — both put extra stress on the belt and will cause the new belt to fail prematurely. Replacing all three in one visit is the most cost-effective repair.
⚙️ Installation
Skill Level: Moderate — 30–45 minutes. Disconnect power before servicing. Remove the dryer front or top panel to access the drum and belt routing. Lift the drum slightly to release tension, remove the old belt, and route the new 12638200000241 around the drum, idler pulley, and motor pulley in the correct orientation. Lower the drum, confirm the belt is seated in all grooves, reassemble the panel, restore power, and run a test cycle to confirm drum rotation.
✓ Compatible Models
Designed for Midea dryers using part number 12638200000241. Contact us to verify your model number before ordering.
💡 Pro Tip
Before pulling the old belt off, take a photo of how it wraps around the idler pulley and motor pulley. Belt routing varies by model and an incorrectly routed belt will slip off immediately or cause the drum to spin in the wrong direction. A 10-second photo saves a full disassembly on the reinstall.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
