GE Front-Load Washer Not Draining or Showing F9E1? Drain Pump WG04F13219 – Fix Standing Water Fast

If your GE front-load washer won’t drain, leaves standing water in the tub after a cycle, or displays an F9E1 drain error code, the drain pump is the cause. In GE GFW550, GFW650, and GFW850 series front-load washers, the drain pump evacuates water from the tub at the end of each wash and rinse cycle — when the pump motor seizes, the impeller jams with debris, or the pump fails electrically, water cannot exit the tub and the washer halts mid-cycle. ⚡ Most common drain failure point in GE front-load washers. Part WG04F13219 is the current OEM replacement (supersedes WG04F11965 and WH11X29539) that restores full drainage and normal cycle completion immediately. OEM and XPart aftermarket options available.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Drain hose has been checked and is not kinked, clogged, or improperly routed
• ✔ Pump filter/coin trap has been cleared of debris
• ✔ Washer powers on and runs normally — only drainage is affected
• ✔ F9E1 drain error code is displayed, or water remains in the tub after the cycle ends
• ✔ ONLY problem is water not draining, slow drainage, or grinding/humming during drain phase

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Washer won’t drain or drains very slowly after the cycle
• Standing water at the bottom of the tub after the cycle ends
• F9E1 drain error code displayed on the control panel
• Loud grinding, humming, or buzzing during the drain phase
• Washer pauses or stops mid-cycle with water still inside
• Pump runs but water level doesn’t drop

✔ If these symptoms match, this is the most likely failed component in the drain system.

✔ In most cases, replacing this drain pump restores full drainage and normal cycle operation immediately.

📦 Part Details

• Part Number: WG04F13219
• Type: Washer Drain Pump — evacuates water from the tub during drain and spin cycles; direct plug-in harness connection, no splicing required
• Replaces: WG04F11965, WH11X29539, 0022150033660401F — no modification required
• Brands: GE
• Options: OEM (WG04F13219) and XPart aftermarket (WH11X29539CM) available — select from the variant selector above

⚙️ Installation

Skill Level: Moderate — 30 to 45 minutes. Disconnect power before beginning. The drain pump is accessed by removing the front lower access panel. Have towels ready — residual water will spill when the pump hoses are disconnected. Disconnect the wire harness and hose clamps, remove the mounting screws, swap the pump, and reconnect. Run a drain-only cycle to confirm full drainage before reassembling the panel.

💡 Pro Tip

PFQ97HSPV0DS, GFW850SPN1RS, GFW850SPN0RS, GFW650SPN3SN, GFW650SPN2SN, GFW650SPN1SN, GFW650SPN0SN, GFW550SSN1WW, GFW550SMN3WW, GFW550SMN2WW, GFW550SMN1WW, GFW550SMN0WW, GFW550SMN0DG

✓ Model-Specific Repair Pages