“WATER STANDING AT THE BOTTOM OF THE DISHWASHER, CYCLE ENDS BUT TUB STILL CONTAINS WATER, DRAIN CYCLE ERROR CODES, LOUD HUMMING OR GRINDING FROM THE BOTTOM OF THE APPLIANCE, DISHWASHER STOPS MID-CYCLE BECAUSE IT CANNOT DRAIN.”
GE Dishwasher drain pump assembly WG04F11356, Fixes “Water standing at the bottom of the dishwasher, cycle ends but tub still contains water, drain cycle error codes, loud humming or grinding from the bottom of the appliance, dishwasher stops mid-cycle because it cannot drain.”
Genuine GE dishwasher drain pump assembly used to remove wastewater from the dishwasher tub. The part is identified by retailers and parts databases as a drain pump assembly for GE dishwashers.
Part WG04F11356Replaces 0120400050CGE
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberWG04F11356
Replaces0120400050C
ManufacturerGE
Appliance TypeDishwasher
Part TypeDishwasher drain pump assembly
✅ Cross Reference Information
0120400050C
Common Symptoms
- “Water standing at the bottom of the dishwasher, cycle ends but tub still contains water, drain cycle error codes, loud humming or grinding from the bottom of the appliance, dishwasher stops mid-cycle because it cannot drain.”
Check Before Replacing
- Remove and clean the filter assembly — a clogged filter is the most common cause of poor drainage
- Inspect the drain hose for kinks, clogs, or improper high-loop installation
- Check the garbage disposal knockout plug if the drain hose connects to a disposal
- Test the pump motor with a multimeter — no continuity confirms a failed motor
Pro Tip
“Before replacing the drain pump, check the drain hose for kinks, blockages, or high-loop issues and ensure the sink drain or garbage disposal is clear. After installing WG04F11356, run a service drain test to verify the pump is evacuating at full speed and that no leaks or abnormal noises are present.”
Part Details
Part NumberWG04F11356
Part TypeDishwasher drain pump assembly
ManufacturerGE
Appliance TypeDishwasher
Installation Notes
- “Disconnect power and water to the dishwasher. Remove the lower kickplate or toe-panel to access the drain pump. Carefully disconnect the drain hose and wiring from WG04F11356, remove mounting screws, swap in the new pump, reconnect wiring and hose, reassemble panel, restore power, and run a test drain cycle.”
Verified Compatible Models
Fitment reminder: Verified compatibility is maintained by the XPart Model Hub Network. Match the complete appliance model number before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
All brand names are the property of their respective owners and are used for compatibility reference only.
