The WG04F11776 is the OEM GE dishwasher water inlet valve that controls the flow of water into the dishwasher tub at the start of each wash and rinse cycle. When the control board signals the valve to open, it allows water to fill the tub to the correct level; when the cycle progresses, the valve closes to stop the fill. A failed inlet valve is one of the most common causes of a dishwasher that won’t fill with water, fills too slowly, or overfills and leaks. This part supersedes 265D3719G001 and WD15X26078 and fits a wide range of GE, GE Profile, Café, Monogram, and Haier dishwashers.

✓ Model-Specific Repair Pages

Don't see your model? Contact us and we'll confirm compatibility. This valve fits 100+ GE, GE Profile, Café, Monogram, and Haier dishwasher models.

The WG04F11776 is a direct OEM replacement manufactured to GE factory specifications. It mounts to the base of the dishwasher and connects to the household water supply line on one side and the dishwasher fill hose on the other. The solenoid coil opens the valve when energized by the control board. This part supersedes 265D3719G001 and WD15X26078 — if either of those numbers appears on your parts diagram, WG04F11776 is the correct current replacement.

✓ Common Symptoms Fixed

Replacing the WG04F11776 water inlet valve typically resolves the following issues:

• Dishwasher not filling with water
• Dishwasher filling too slowly or taking too long to start a cycle
• Dishwasher overfilling or leaking water onto the floor
• Humming sound from the valve area with no water entering the tub
• Dishes not getting clean due to insufficient water

✓ Key Features & Specifications

• OEM GE part number: WG04F11776
• Supersedes: 265D3719G001, WD15X26078
• Barcode: 0791484521845
• Solenoid-operated water inlet valve
• Mounts to dishwasher base, connects to supply line and fill hose
• Compatible with 100+ GE, GE Profile, Café, Monogram, and Haier dishwasher models

✓ Buying Options

OEM (WG04F11776): The genuine GE dishwasher water inlet valve. Factory-calibrated solenoid and flow rate specifications for reliable fill cycles and leak-free operation.

✓ Replacement Part Numbers

WG04F11776 replaces the following part numbers:

• 265D3719G001
• WD15X26078

✓ Installation Tips

• Disconnect power and shut off the water supply valve under the sink before beginning.
• Pull the dishwasher forward from the cabinet to access the base (remove the toe kick panel first).
• Locate the water inlet valve at the front-left base of the dishwasher.
• Disconnect the water supply line, the fill hose, and the electrical connector from the valve.
• Remove the mounting screws and pull the old valve free.
• Install the new WG04F11776 valve, reconnect the supply line, fill hose, and electrical connector.
• Restore water and power, then run a test cycle and check for leaks at all connections.