Blomberg Washer Pump-filter Assembly 2808902200

Is This the Right Part?

Common Symptoms

• Water remains in the drum after the cycle.
• The washer stops or cannot proceed normally because draining is incomplete.
• Restricted discharge caused by debris in the pump-filter area.
• Unusual pump-area noise may occur when a hard object enters the filter area.

Check Before Replacing

• Disconnect or unplug the washer before inspecting or servicing the pump-filter area.
• Allow hot water in the washer to cool before opening the filter area to reduce scalding risk.
• Use the washer’s emergency drain hose, if provided, to drain water into a suitable container before removing the filter.
• Inspect the pump-filter area for coins, buttons, fibers, or other residues and check the impeller region for visible obstructions.
• Check that the external drain hose is not folded or obstructed before attributing the symptom to the pump-filter assembly.
• After cleaning or replacement, ensure the filter is fully seated and check for leakage during a supervised drain operation.

Pro Tip

Part Details

Installation Notes

• Disconnect power before servicing the assembly or touching pump wiring.
• Drain the washer completely before opening or removing the pump-filter assembly; residual water may be present.
• Use the model-specific service documentation for access, hose, wiring, and mounting details because those details are not documented in the available part listing.
• Inspect hose connections and seals during reassembly and confirm the filter or cap is properly seated before operating the washer.
• Run a supervised drain check after installation and stop if water leaks.

Verified Compatible Models

7161141300, 7161141400

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.