Dishwasher Not Filling with Water? Water Inlet Valve 10023853 – Fix No-Fill Fast

A dishwasher that won't fill is almost always a failed water inlet valve. In most Bosch and Siemens dishwashers, this solenoid-controlled valve is the single point of failure when water stops entering the tub. When it fails, the dishwasher starts a cycle but never fills, runs dry, or triggers an E24/E25 error. ⚡ Common failure point in Bosch-built dishwashers after 5–8 years of use. Part 10023853 is the genuine OEM replacement that restores full water flow and normal wash cycle operation immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your dishwasher powers on and starts a cycle normally
• ✔ The door latch, control board, and drain pump all appear functional
• ✔ Household water supply to the dishwasher is confirmed on and at adequate pressure
• ✔ The fill hose and inlet screen are clear of debris or kinks
• ✔ ONLY problem is the dishwasher not filling with water, filling too slowly, or stopping mid-cycle

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Dishwasher starts cycle but tub never fills with water — most common complaint
• Dishwasher fills very slowly or only partially
• E24 or E25 error code displayed on control panel
• Humming sound at start of cycle but no water entering tub
• Dishwasher runs full cycle but dishes come out dirty and dry
• Water inlet valve visibly cracked, corroded, or leaking at connection point

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this water inlet valve restores normal operation immediately.

📦 Part Details

• Part Number: 10023853
• Type: Dishwasher Water Inlet Valve — dual solenoid, OEM specification
• Replaces: OEM direct-fit water inlet valve assembly — supersedes 00637572 (no modification required)
• Brands: Bosch, Siemens, and compatible Bosch-platform dishwashers

⚙️ Installation

Skill Level: MODERATE — 20–30 minutes. Disconnect power and shut off the water supply valve under the sink before beginning. Remove the lower kick panel, disconnect the water supply line and wiring harness from the old valve, and transfer the inlet hose to the new valve. Torque the supply line fitting to hand-tight plus a quarter turn — do not overtighten or you risk cracking the valve body.

💡 Pro Tip

🔗 Model Repair Hubs

SHE3AR72UC, SHE3AR75UC, SHE3AR76UC, SHE3ARF2UC, SHE3ARF5UC, SHE3ARF6UC, SHEM3AY55N, SHS5AV52UC, SHS5AV55UC, SHS5AV56UC, SHS5AVF2UC, SHS5AVF5UC, SHS5AVF6UC, SHX3AR72UC, SHX3AR75UC, SHX3AR76UC, SHX5AV52UC, SHX5AV55UC, SHX5AV56UC, SHX5AVF5UC, SHXM4AY55N. Contact us to verify your model number before ordering.

✓ Model-Specific Repair Pages