GE Washer Rod and Spring Assembly WW01F01681, Replaces 233D2080G001
Front short red suspension rod. Supports the tub and controls movement during agitation and spin.
WW01F01681 GE Suspension Rod and Spring for Washers, Fixes Shaking or an Unbalanced Tub
WW01F01681 is a genuine GE/Mabe washer suspension rod and spring assembly corresponding to engineering number 233D2080G001. The assembly is identified as the front short red suspension rod on compatible top-load washers. It supports the tub and helps control movement during agitation and high-speed spin.
A bent, detached, stretched, or weakened suspension rod may contribute to excessive shaking, a leaning tub, repeated unbalanced-load interruptions, banging, or the washer moving across the floor. Similar symptoms can also result from another worn suspension rod, damaged upper suspension joints, incorrect levelling, uneven flooring, overloading, or a drive-system problem.
Suspension rods are position-specific. Confirm the complete washer model, rod position, overall length, and colour identification before ordering. Inspect all suspension rods and upper supports before deciding whether to replace one rod or the complete matched set.
Disconnect electrical power and shut off the water supply before moving or servicing the washer.
Is This the Right Part?
Confirm the complete model number before ordering. Suspension rods may differ by position, length, spring tension, and colour identification. WW01F01681 is the front short red rod corresponding to 233D2080G001 and is not interchangeable with other position-specific rods.
Common Symptoms
- Excessive shaking or vibration during agitation or spin
- Tub leaning to one side or sitting unevenly
- Washer moving or walking across the floor during operation
- Repeated unbalanced-load error interruptions
- Tub striking the cabinet walls during spin
- Banging or thumping during the wash or spin cycle
Check Before Replacing
- Inspect all suspension rods — a single failed rod is often accompanied by wear on the others
- Check upper ball joints and suspension sockets for cracks or deformation
- Verify the washer is level and the levelling feet are properly adjusted
- Confirm no shipping or packing material has been left inside the cabinet
- Check load size and distribution — overloading causes repeated unbalanced interruptions
Part Details
Installation Notes
- Disconnect electrical power and shut off the water supply before servicing.
- Photograph all rod positions, upper sockets, and mounting points before disassembly.
- Compare the new rod with the original before installation — verify length, spring, colour, and ball joint.
- Inspect the upper suspension socket for cracks or deformation before reinstalling.
- Seat the lower ball joint into the tub bracket first, then engage the upper socket into the cabinet hook.
- Inspect all remaining rods and replace any that are bent, stretched, or corroded.
- Restore power and run a spin cycle to verify smooth, balanced tub operation.
Use a qualified technician when diagnosis or installation is outside your experience.
Verified Compatible Models
GTW220BMK0WW, GTW220BMK1WW, GTW330BMK0WW, GTW330BMK1WW, MTW200BMK0WW
Fitment reminder: Match the complete model number, including suffixes and revision digits, before ordering. Contact us to verify your model number.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
