GE / General Electric Dryer lint filter / filter and mesh assembly WG04F07468, Replaces 212D1090G01, 212D1660P002, WE18M41, WE18M53

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Visible tears, holes, cracks, or deformation in the filter or mesh
• Lint remaining on clothing despite a clean filter
• Longer-than-usual drying time when the filter is damaged, clogged, or not sealing correctly
• Clothes or fabric catching near the lint-filter area

Check Before Replacing

• With the dryer stopped and cool, remove the filter and inspect the mesh, frame, and edges for tears, holes, cracks, or distortion.
• Hold the clean, dry filter up to a light and check for damaged or open areas in the mesh.
• Confirm that the filter seats fully and evenly in its installed position without rocking or leaving an obvious gap.
• Clean the filter before checking performance; wash periodically with warm soapy water if fabric-softener residue is present, then dry it thoroughly before reinstalling.
• If drying is slow, also check that the external exhaust duct is clean, unobstructed, and free of severe kinks; these symptoms are not unique to the filter.

Pro Tip

Part Details

Installation Notes

• Turn the dryer off and allow it to cool before handling the filter.
• Remove the existing filter according to the dryer's owner instructions, then install the replacement in the same filter slot and orientation.
• Verify that the assembly is fully seated and stable before operating the dryer.
• Do not operate the dryer without the lint filter in place.
• If access requires service beyond removing the filter, disconnect electrical power and follow the model-specific service instructions.

Verified Compatible Models

GTMS940EEWS00, GTMS940GEWS00, GTMS945EEGG00, GTMS945GEGG00, SGC620DEBB00, SGC620DPBB00, SGC630NDEBB00, SGC630NDPBB00, SGE1222EMSBB01, SGE1222PMSBB01, SGE1225JMSBB00, SGE1225JMSBB01

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.