Whirlpool Washer door lock assembly WPW10192995, Replaces W10192995

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Washer will not start because the door-lock signal is not confirmed
• Washer stops or fails to advance after attempting to lock the door
• Door-lock indicator flashes or remains incorrect
• Door remains locked after cancellation or does not release at the end of a cycle

Check Before Replacing

• With the washer empty and power disconnected, visually inspect the door-lock opening and door strike area for clothing, debris, misalignment, or binding.
• Confirm the door closes fully and the strike enters the lock without excessive force; do not force the door.
• Check the door-lock electrical connector and visible wiring for looseness or damage only after disconnecting power.
• If the washer provides a service-diagnostic mode, use the model-specific procedure to check the door-lock system and stored door-related fault codes.
• Do not replace the lock based only on a no-start or spin symptom; verify that the door-lock mechanism, strike, wiring, and control circuitry are not the actual cause.

Pro Tip

Part Details

Installation Notes

• Disconnect electrical power before servicing.
• Open the washer door and carefully release the bellows retaining wire so the bellows can be folded back near the lock.
• Remove the retaining screws, pull the lock assembly clear of the front panel, and disconnect its electrical connector.
• Reconnect the replacement assembly, reinstall the retaining screws and bellows retaining wire, and restore all panels and parts before operation.
• Run the model-specific functional or diagnostic check after installation to confirm that the door locks and releases correctly.

Verified Compatible Models

MHWC7500YW0, WFC7500VW0, WFC7500VW1, WFC7500VW2

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.