Menu
Wall Oven Not Responding or Heating Incorrectly? Control Board WPW10292566 – Fix Oven Errors Fast
If your Jenn-Air or Maytag wall oven won't heat, displays error codes, or has unresponsive controls, the electronic control board is the most common cause. In most JJW and JMW series wall ovens, the control board manages all temperature, timing, and function logic. When it fails, the oven may not heat at all, display fault codes, lock up, or behave erratically. ⚡ Common failure point in Jenn-Air and Maytag-built wall ovens. Part WPW10292566 is the genuine OEM replacement control board that restores full oven operation — no modifications required.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Oven has power — clock or display shows something (even an error)
- ✔ Door latch, light, and fan operate but heating does not
- ✔ Household breaker is not tripped and supply voltage is confirmed
- ✔ Temperature sensor has been tested and reads within spec (~1100 ohms at room temp)
- ✔ ONLY problem is no heat, wrong temperature, error codes, or unresponsive keypad
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Oven won't heat on bake or broil — most common, what customers search
- Display shows F1, F2, F3, F7, or other fault codes
- Oven heats to wrong temperature or overshoots setpoint
- Keypad buttons unresponsive or intermittently work
- Oven shuts off mid-cycle without completing cook time
- Control panel blank or flickering despite power being on
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this control board restores normal oven operation immediately.
📦 Part Details
- Part Number: WPW10292566
- Type: Electronic oven control board (EOC) — wall oven, 240V
- Replaces: OEM direct-fit control board — supersedes W10292566, W10289533, W10175827 (no modification required)
- Brands: Jenn-Air, Maytag
⚠️ Recommended While Repairing:
Before replacing the board, test the oven temperature sensor — a failed sensor can mimic control board symptoms and damage a new board if left in place. If the sensor reads outside 1080–1120 ohms at room temperature, replace it at the same time.
Before replacing the board, test the oven temperature sensor — a failed sensor can mimic control board symptoms and damage a new board if left in place. If the sensor reads outside 1080–1120 ohms at room temperature, replace it at the same time.
⚙️ Installation
Skill Level: Moderate — 30–45 minutes. Disconnect power at the breaker before starting — this board carries 240V and must be fully de-energized. Remove the oven's rear or top access panel to reach the control board, photograph all wire harness connections before disconnecting, swap the board, and reconnect all harnesses in the same positions. Avoid touching board components directly — handle by edges only to prevent static damage.
💡 Pro Tip
Clear the Fault Code After Install:
After replacing the control board, restore power and perform a hard reset by cycling the breaker off for 60 seconds before turning back on. This clears any stored fault codes from the previous board and allows the new board to initialize cleanly. If a fault code returns immediately after reset, the root cause (sensor, relay, or wiring) should be investigated before assuming the board is defective.
After replacing the control board, restore power and perform a hard reset by cycling the breaker off for 60 seconds before turning back on. This clears any stored fault codes from the previous board and allows the new board to initialize cleanly. If a fault code returns immediately after reset, the root cause (sensor, relay, or wiring) should be investigated before assuming the board is defective.
✓ Compatible Models
Confirmed compatible with JJW2327WB00, JJW2327WS00, JJW2330WB00, JJW2330WS00, JJW2330WS01, JJW2427WB00, JJW2427WS00, JJW2430WB00, JJW2430WP00, JJW2430WR00, JJW2430WS00, JJW2430WW00, JJW3430WB00, JJW3430WP00, JJW3430WR00, JJW3430WS00, JJW3830WB00, JJW3830WP00, JJW3830WR00, JJW3830WS00, JMW2327WB00, JMW2327WS00, JMW2330WB00, JMW2330WS00, JMW2427WB00, JMW2427WS00, JMW2427WW00, JMW2430WB00, JMW2430WP00, JMW2430WR00, JMW2430WS00, JMW2430WW00, JMW3430WB00, JMW3430WP00, JMW3430WR00, JMW3430WS00, plus additional JJW and JMW series models. Contact us to verify your model number before ordering.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
- Choosing a selection results in a full page refresh.
