Washer Not Filling? Water Inlet Valve 5304528029 – Fix No-Fill Fast
When your washer won't fill with water — or fills too slowly — the water inlet valve is the #1 cause. In most Frigidaire and Electrolux front-load and top-load washers, this is caused by a failed water inlet valve. When it fails, the tub never fills, cycles stall at the fill stage, or the machine leaks from the valve body. ⚡ Common failure point in Frigidaire-built washers. Part 5304528029 is the genuine OEM replacement that restores proper hot and cold water fill immediately.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your washer powers on and the control panel responds normally
- ✔ Water supply hoses are connected and shutoff valves are fully open
- ✔ Home water pressure is confirmed adequate (20–120 PSI)
- ✔ ONLY problem is the washer won't fill, fills slowly, or leaks at the valve
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Washer won't fill with water or takes much longer than normal to fill
- Washer fills with only hot or only cold water (one solenoid failed)
- Water leaking from the back of the machine at the valve body
- Error codes related to water fill (e.g., E11, E13, or similar fill fault codes)
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this water inlet valve restores normal fill operation immediately.
📦 Part Details
- Part Number: 5304528029
- Type: Dual-solenoid water inlet valve (controls hot and cold water fill into washer tub)
- Replaces: 5304514790, 5304522534, A06625801, 33950008
- Brands: Frigidaire, Electrolux
While the back panel is open, inspect the inlet hose screens (mesh filters at the hose connections). Clogged screens are a leading cause of slow fill and are often mistaken for a failed valve. Clean or replace them at the same time — it takes 5 minutes and prevents a repeat call.
⚙️ Installation
Skill Level: Easy — 20–35 minutes. Disconnect power and shut off both water supply valves before starting. Remove the back access panel (typically 4–6 screws), disconnect the water hoses and electrical connector from the old valve, transfer the hoses and connector to the new valve, and reinstall. No special tools required beyond a nut driver or screwdriver.
✓ Compatible Models
Confirmed compatible with EFLS527UIW0, EFLS527UIW1, EFLS527UIW2, EFLS627UIW0, EFLS627UIW1, EFLS627UTT0, EFLS628WTT00 plus additional Frigidaire and Electrolux washer models. Contact us to verify your model number before ordering.
💡 Pro Tip
If you have a multimeter, test each solenoid coil on the old valve before replacing it. A good solenoid reads 200–500 Ω; an open reading (OL) confirms the coil is burned out. This rules out a wiring harness issue and confirms the valve is the correct fix — saving you from ordering a part you don't need.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
